Abstract
Virtual synchronous generator (VSG) technology has achieved some results in distributed generation networks and enhanced system stability. For problems that may occur in the system due to ignoring parameter linkages, this paper designs a synergistic controller that establishes the connection between the active frequency and the reactive voltage control loop based on synergy theory. As the output of the synergetic controller, the derived control law u is added to the power frequency control in the form of negative feedback. Two disturbance forms, a step disturbance, and a three-phase short-circuit fault, are set up. The conventional droop control and synergetic droop control results are compared using a MATLAB simulation system. Then, the system parameter variations were studied and analyzed, and the sensitivity of the control system with different values of parameters K1, K2, and K3 in the case of a three-phase short circuit was analyzed, which provides a reference guide for selecting parameters in later control optimization. Finally, the control effectiveness of a multi-machine VSG system was tested. The simulation results show that the proposed method has a pronounced effect on making the system stabilize quickly, which illustrates the effectiveness of this technique.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.