Abstract
With the development of engineering technology, FEM can be used to simulate metal machining process and gain better understanding of material flow within dies, so as to optimize tooling to eliminate tears, laps and other forging defects. In this paper, numerical simulation was conducted by using FEM software on the whole cutting process for TC4 alloy mounting parts in an effort to investigate the metal flow behavior. The thermal simulation results obtained were compared with the cutting temperature and discussed in terms of literature data.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.