Active shape change of an SMA hybrid composite plate

Abstract

An experimental study was carried out to investigate the shape control of plates via embedded shape memory alloy (SMA) wires. An extensive body of literature proposes the use of SMA wires to actively modify the shape or stiffness of a structure; in most cases, however, the study focuses on modeling and little experimental data is available. In this work, a simple proof of concept specimen was built by attaching four prestrained SMA wires to one side of a carbon fiber laminate plate strip. The specimen was clamped at one end and tested in an environmental chamber, measuring the tip displacement and the SMA temperature. At heating, actuation of the SMA wires bends the plate; at cooling deformation is partially recovered. The specimen was actuated a few times between two fixed temperatures <TEX>$T_c$</TEX> and <TEX>$T_h$</TEX>, whereas in the last actuation a temperature <TEX>$T_f$</TEX> > <TEX>$T_h$</TEX> was reached. Contrary to most model predictions, in the first actuation the transformation temperatures are significantly higher than in the following cycles, which are stable. Moreover, if the temperature <TEX>$T_h$</TEX> is exceeded, two separate actuations occur during heating: the first follows the path of the stable cycles; the second, starting at <TEX>$T_h$</TEX>, is similar to the first cycle. An interpretation of the phenomenon is given using some differential scanning calorimeter (DSC) measurements. The observed behavior emphasizes the need to build a more comprehensive constitutive model able to include these effects.