Active Control of Fuel Position in Opposed-Flow Strand Burner Experiments

Abstract

ABSTRACT This paper describes a new active method of controlling the position of the burning surface of a solid fuel strand in an opposed-flow burner experiment. This method is designed to avoid biases to the combustion process introduced by retaining wires and to avoid experimental delays caused by wire failures. Regression rates are presented for hydroxyl-terminated polybutadiene fuel strands burning in various oxidizer streams. The active control method uses a control loop composed of a diode laser, a photodiode, and a stepper motor. For comparison, tests were also performed using the commonly used passive control method of spring-loading the fuel against a retaining wire. This active control method can only be used at high values of oxidizer mass flux; at low mass flux, soot accumulation obstructs the laser beam. In passive control tests, the retaining wire conducts heat from the flame into the fuel and increases regression rate. The presence of the wire also modifies the extinction limits of the flame. A model was developed for regression rate as a function of oxidizer mass flux, oxidizer composition, and retaining wire diameter. This model can be used to correct future regression rate data for the bias introduced by retaining wires.