A small‐area and low‐power data driver IC using two‐stage DAC with a capacitor array for active matrix flat‐panel displays

Abstract

AbstractA small‐area and low‐power data driver integrated circuit (IC) using a two‐stage digital‐to‐analog converter (DAC) with a capacitor array is proposed for active matrix flat‐panel displays. The proposed data driver IC employs a capacitor array in the two‐stage DAC so as to reduce the DAC area and eliminate the need for a resistor string, which has high‐power consumption. To verify the proposed two‐stage DAC, a 20‐channel data driver IC with the proposed 10‐bit two‐stage DAC was fabricated using a 0.18‐μm complementary metal–oxide–semiconductor process with 1.8 and 6 V complementary metal–oxide–semiconductor devices. The proposed 10‐bit two‐stage DAC occupies only 43.8% of the area of a conventional 10‐bit two‐stage DAC. The measurement results show that the differential nonlinearity and integral nonlinearity are +0.58/−0.52 least significant bit and +0.62/−0.59 least significant bit, respectively. The measured interchannel deviation of the voltage outputs is 8.8 mV, and the measured power consumption of the 20‐channel data driver IC is reduced to 7.1 mW, which is less than half of the power consumed by the conventional one.