3D Photoelasticity And Numerical AnalysisOf A Cylinder/half-space Contact Problem

Abstract

The three-dimensional analysis of contact mechanics is still not an easy task. Frozen stress techniques in photoelasticity have been used very much to obtain the stress fields developed in the models. Although the means to avoid the introduction of residual stresses are well established, these techniques remain time consuming. Owing to the recent developments in technology of image recording and processing, new non-destructive methods have been developed to circumvent these difficulties. In this paper, a new non-destructive method of optical slicing of a photoelastic model was used to analyse stresses developed in a half space by a rigid cylinder. The basic idea is to use the properties of polarization of the scattered light. The slice is isolated in the model by two laser sheets. A speckle pattern due to the interference of the light beams of each section in the direction perpendicular to these plans can be observed. The possibility of interference depends on the birefringence of the isolated slice. A high resolution CCD camera is used to take pictures of the two illuminated sections. The stress field can then be analyzed using software. This technique allows us to visualise photoelastic fringes at any given position within the model. Comparisons are made between experimental fringes and calculated fringes obtained by a numerical analysis using “Castem” package. The obtained results show close agreement between numerical predictions and the experimental results.