2-D modeling of torrefaction of a large biomass particle: effect of L/D ratio, internal convection and shrinkage

Abstract

ABSTRACT Torrefaction of a large biomass particle was investigated using a transient 2-D model, including primary and secondary reactions kinetics and heat transfer, internal convection, and shrinkage. The model predictions matched with the experimental results within +2%. Spatial and temporal distributions of temperature, residual mass fraction, velocity, and pressure inside the particle and the effect of reactor temperature, residence time, particle size, and shrinkage on the torrefaction behaviour were investigated. Evolution of moisture, volatiles and gases due to drying and torrefaction increase the pressure inside the particle, setting up a velocity field and internal convection. Average velocity and pressure reached a peak during the initial drying period due to moisture evolution, and a subsequent second peak due to the formation of volatiles and gases by torrefaction at a reactor temperature > 493 K. Internal convection influenced torrefaction significantly but the particle shrinkage did not impact it appreciably. The degree of overshoot of the particle center temperature above the reactor temperature increased with the reactor temperature and the particle diameter. Simulations suggest that a reactor temperature of 550 K and residence of about 30 min would be suitable for torrefaction of a particle with L = D = 25.4 mm.