Abstract
Introduction. New grades of high-strength steels, machining and repair processes are being introduced in the power industry. At the same time manual arc welding remains the main technological process for equipment repair in conditions of thermal power plants. Welding materials used in equipment repair should provide comparable to the base metal mechanical properties of the weld. The welding industry has long faced the problem of high sensitivity of basic type electrodes to moisture absorption. High susceptibility to cold cracking caused by diffusible hydrogen and hydrogen embrittlement are major obstacles to the wider use of basic-type electrodes for high-strength steels. Hydrogen production during arc welding is the result of the presence of hydrogen in the arc atmosphere, hydrogen-contaminated filler material, or local hydrogen residues on the source material. During welding, molecular hydrogen is dislocated by the arc energy and then easily absorbed by the molten material. Currently, the welding materials market produces electrodes with basic coating of well-known and proven brands, various national and foreign manufacturers. However, in practice there are cases of cold cracks in the weld seam after welding. Purpose of work is to assess the welding and technological properties of basic type electrode coatings of different manufacturers. The work investigates specimens weld overlaid with electrodes TMU-21U, TSU-5 of different manufacturers and the content of diffusion-mobile hydrogen in the weld overlaid metal is determined. The methods of research are mechanical static tensile tests, chemical composition analysis and metallographic studies. Determination of welding-induced hydrogen content can be accomplished by various quantitative elemental analysis methods. All test methods involve welding under defined conditions followed by deep freezing of the test specimens as quickly as possible. In this way, unintended diffusion processes are inhibited and the hydrogen introduced into the weld metal is retained. Subsequently, the diffusing hydrogen is desorbed from the test specimens in a controlled manner. Results and Discussion. An assessment of welding engineering properties of the electrodes revealed unstable arc burning. Mechanical properties of the welded metal of the investigated electrodes are at the minimum permissible level from the requirements of normative documents. The concentration of hydrogen present in the arc weld metal is multifactorially dependent on the welding procedure (process and parameters, consumables used, as well as environmental conditions (e.g. humidity). For qualitative assessment, hydrogen content of more than 15 cm3/100 g is considered high and hydrogen content less than 5 cm3 ml/100 g is considered very low. Presented results. The conducted evaluation of welding engineering properties of electrodes with basic coating showed satisfactory results. Mechanical properties of the welded metal in terms of impact toughness are at the lower permissible limit, relative elongation does not meet the requirements of normative documents. The content of diffusion-mobile hydrogen in the welded metal is higher than the declared indicators by the electrode manufacturers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.