Разработка и исследование подхода к обработке сигналов цифровых измерительных трансформаторов тока и напряжения

Abstract

During the development of secondary systems of stations and substations, including relay protection, automation, control, electricity metering, etc., qualitative changes have recently occurred due to the introduction of digital technologies. The introduction of digital technologies is supported by innovative development programs such as “Digital Transformation 2030”. The introduction of digital technologies is associated with the use of digital data transmission channels according to uniform standards. Projects of “digital substations” are being actively implemented with the transmission of digital information at all levels, including the primary equipment, the transmission of information both from current and voltage measuring transformers, and from switching devices. Currently, digital instrument transformers are actively being developed and implemented, in which information about measured currents and voltages is presented in digital code. New approaches to measure primary currents and voltages, and transmit information pose new challenges, and open prospects for improving signal processing methods used for relay protection purposes. Thus, the relevant aim of the study is the development and research of approaches to digital processing of signals of digital instrument current and voltage transformers. To solve the problems posed within the framework of this study, analytical and numerical solution methods have been used. Numerical methods are applied using software products such as MathCAD and the Python programming language to generate signals and display them on graphs. To substantiate the reliability, verification of the results obtained by different methods is carried out. The authors have formulated an approach to digital processing of signals obtained using current sensors of a digital instrument transformer. The authors have studied the approach to determine synchronized current vector values by processing information received from primary current converters. The characteristics of the algorithm for obtaining a vector have been analyzed and the dependences of errors on the influence of distorting factors have been plotted. The proposed approach is a development of the existing approach to obtain a vector by getting information from current sensors operating on different physical principles. The results show the advantages of the proposed method. The proposed digital signal processing algorithm is more technically expensive since it contains at least two metrologically calibrated measuring channels instead of one. However, all other things being equal, it allows to increase the accuracy and speed of the digital processing algorithms taken as a prototype. The results obtained can be used to formulate algorithms for measuring relay protection devices.