Abstract

A printing press is a complex technical system that includes a large number of rotating parts (shafts, gears, etc.), including bearings and support rollers. The appearance of defects in bearing assemblies can lead to serious consequences, such as equipment failure and jamming of shafts, which will lead to a halt in production or the appearance of defective printed products. The purpose of the work was to study defects in the support roller of the gripper shaft, which is responsible for transferring the sheet inside the printing section. The defects of the outer ring of the support roller are considered in the article. With the help of a control and measuring machine, the changes that occur in its geometry are studied. The research was carried out on the new roller, as well as on the rollers that came out of operation, the changes that occur during operation were revealed. Also, with a tenfold increase, defects that occur on the surface of the ring that appeared during operation, such as abrasive wear, traces of fatigue, were studied.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.