A material plastic flow finite-element modeling during pressure welding (PW) of two-element and three-element samples was carried out for dissimilar wrought (EP975) and cast intermetallic (VKNA-type) alloys at 1125°C and 10-4 s-1 initial strain rate. The finite-element modeling was performed in a two-dimensional set-up (plane strain). In the two-element samples case, the top element was ultrafine grained EP975 and the bottom one was VKNA-25. The top and bottom elements of the three-element samples were made from VKNA-25 while the intermediate element was ultrafine-grained EP975. The geometry in the X and Y directions were 40.5 and 5 mm for the EP975 samples and 40.5 and 3 mm for the VKNA-25 samples respectively. Experiments on PW intermetallic Ni3Al alloy and heat-resistant nickel alloy EP975 with ultrafine-grained (UFG) structure were carried out. Samples were parallelepipeds of size 10x40x3 mm3 and 10x40x5 mm3 respectively. PW was carried out at 1125 ˚C. Several combinations of welded sample surfaces with flat and grooved relief were considered. The relief made on both welded surfaces was equivalent to increase of friction between them. This results in a shear deformation reduction near the contact surfaces and degrades the welding quality as compared to the flat surfaces conventional welding. Relief applied only to one of the elements being welded results in a more efficient welding process since active deformation zones are created in the central zone, where in the other samples stagnant zones are observed. There are no deformation peculiarities in PW of the three-element samples, compared to two-element sample.