A procedure is described in which thick sections (2-10 mu or more) of plastic-embedded plant tissues are mounted in serial order on slides for use in routine light microscopy. Sections are cut with a steel knife on a rotary microtome while the block and blade are bathed with 40% alcohol. The cut sections are placed, in order, in 50% alcohol in the small wells of modified plastic trays where they become flat, pliable and suitable for subsequent handling. Sections remain separate and in correct order in the trays while they are stained, washed, and prepared for final mounting on slides. Mounting involves a simple and rapid procedure of transferring the sections to a slide and heating first on a 70-75 C hot plate (to slowly evaporate the water around the section and to partially affix the section) and then on a C hot plate. This second heating ensures adhesion when xylene-base mounting media, which tend to loosen weakly adhered plastic from the slides, are used. The technique of staining the sections loose provides the following advantages: (1) the problems of section loss and entrapment of stain between section and slide during staining are eliminated, (2) relatively high staining temperature, alkalinity, and alcohol concentration of the stain solvent (all of which promote loosening of pre-affixed sections from slides during staining) is allowed, and (3) staining is more even and selective. The procedure has been found to be reliable and fast enough to be of value in a significant variety of routine light microscope studies.