AbstractElectrodes are used to measure a potential difference between two points. In geophysical and geotechnical applications they are often in the form of non‐polarizable porous‐pot electrodes. Here we describe the design, construction, and testing of modular and refillable electrodes, which facilitates repair as the electrodes degrade over time. We use a chemical composition based on a metal in contact with an over‐saturated electrolyte that consists of a salt of that metal and an auxiliary salt. We compare characteristics when the electrolyte is stabilized in a clay or not, and with various states of ceramic porous plugs and two types of wood plugs. Next, we assess the long‐term stability (more than 1 month), noise (periods of 1 s to 1 hr), and temperature sensitivity of different types of electrodes. Electrodes with an electrolyte and clay formula showed lower noise (0.2–0.4 μV at periods of 1–120 s), greater long‐term stability (0.05–0.5 mV/month of smooth drift), and greater consistency between samples measured than those with no clay (noise and drift values up to four times larger). The effects from different porous plugs were negligible, with similar results for ceramic and wood types. The temperature sensitivity of the electric potential was assessed, from −3 to 35°C. All electrodes showed a temperature sensitivity of about −30 μV/°C. This is considered very low compared to some commercially available electrodes. Finally, continuous long‐term laboratory and field measurements of the potential highlight the application of the new electrodes.