The purpose of this study was to investigate the influence of light intensity on dentin bond strengths of four self-etch adhesive systems. The light intensities used to polymerize specimens were controlled at levels of 150, 300, 600, and 900 mW/cm2. The two-step self-etch adhesive systems Imperva Fluoro Bond and Mac Bond II, and the one-step self-etch systems Fluoro Bond Shake-One and One-Up Bond F Plus were used with their corresponding light-cured resins. Labial surfaces of lower bovine incisors were ground with #600 grit SiC paper to expose the dentin. The dentin surfaces were treated according to each manufacturer's instructions and bonded with resin composites. A shear bond strength test was performed and the data were analyzed by one-way ANOVA followed by Newman-Keuls multiple comparison at a level of 0.05. Statistical analysis of the data indicated that light intensity affected the dentin bond strengths of the adhesive systems tested. Significantly lower bond strengths were obtained by exposure to 150 mW/cm2, and there were no differences between the bond strengths obtained at 600 and 900 mW/cm2 for all the adhesive systems used. Further research will be required to clarify the irradiance-dependent properties of light-cured resin adhesive systems.