This work is focused on carbonate paleosols developed in three stratigraphic sections (Landete, Talayuelas and Henarejos) of the Middle–Late Permian Alcotas Formation in the SE Iberian Basin. The Alcotas Formation, of alluvial origin, was deposited in semi-connected half-grabens developed during the early stages of the Permian–Triassic rifting stage that affected the Iberian Basin. The studied sections were located in two of these half-grabens, the Henarejos section being much closer to the basin boundary fault than the other two sections. The mineralogy and texture of the carbonate precursor of paleosols in the three studied sections are not preserved because original carbonate is replaced by coarse crystals of dolomite and/or magnesite. Dolomite crystals are typically euhedral, displaying rhombohedral shapes and reddish luminescence, although in the Henarejos section dolomite displays non-planar boundaries and frequently saddle habit. Micas are deformed and adapted to dolomite crystals, which, in turn, are affected by stylolites, suggesting that dolomite precipitated before mechanical and chemical compaction. Carbon and oxygen isotopic compositions of dolomite from the three sections show different values (δ 13C VPDB mean values = − 6.7‰, − 5.5‰ and − 7.5‰; δ 18O VPDB mean values = − 4.0‰; –5.6‰ and − 8.2‰, at Landete, Talayuelas and Henarejos sections, respectively). The 87Sr/ 86Sr ratios are similar in the three sections yielding values between 0.71391 and 0.72213. The petrographic and geochemical features of dolomite in the three studied sections suggest precipitation from similar fluids and during shallow burial diagenesis. Assuming that the minimum temperature for dolomite precipitation in the Henarejos section was 60 °C (as suggested by the presence of non-planar saddle habit), and that the dolomitizing fluid had similar δ 18O values at the three localities, then dolomite in the Talayuelas and Landete sections precipitated at temperatures around 16 and 25 °C cooler, respectively. In addition, the δ 18O VSMOW values of the water from which dolomite precipitated would have ranged between − 0.3 and − 2.9‰. Dolomite is partially or totally replaced by non- to dark dull luminescent magnesite in the Landete and Talayuelas sections. Magnesite crystals are affected by stylolites, indicating that it precipitated before chemical compaction. The δ 13C mean values are − 6.5 and − 6.0‰ and the δ 18O VPDB mean values are − 6.7 and − 7.8‰, in the Landete and Talayuelas sections, respectively. The 87Sr/ 86Sr ratios of magnesite are similar in both sections yielding values between 0.71258 and 0.72508. This suggests that they probably precipitated from similar fluids during progressive burial and at higher temperatures than dolomites at the same sections. Assuming that magnesite precipitated from a fluid with similar δ 18O values in both sections, then it had to precipitate at a temperature around 8 °C higher in Talayuelas than in the Landete section. Dolomitisation and magnesite precipitation probably occurred via reflux of saline to hypersaline brines from the overlying Mid-Late Triassic Muschelkalk and/or Keuper facies. The temperatures inferred for dolomite precipitation, however, are too high for shallow burial if a normal geothermal gradient is applied. Thus, it can be inferred that saline fluids were heated as they flowed through the syn-sedimentary extensional faults that controlled Middle Permian to Middle Triassic sedimentation; consequently fluids would have been at higher temperatures near the Henarejos area, which was closer to the basin boundary fault than at the Talayuelas and Landete areas, which were situated further away. This contention is in agreement with recent studies which demonstrate that an important thermal event took place during Late Triassic–Early Jurassic times in the Iberian Peninsula.
Read full abstract
Feb 27, 2014
Víctor H García + 1
Open Access