Washing Wastewater Treatment Research Articles

Characterization of a thermal power plant air heater washing waste: a case study from Iran

In Iran most of the electricity is generated by thermal power plants. As a result of fuel oil burning in winter time, the air heaters of the boilers have to be washed and cleaned frequently. The wastewater originating from air heater washing is then treated in an effluent treatment plant by chemical precipitation followed by dewatering of the sludge produced. The resulting waste is classified as specific industrial waste that should be characterized in detail under the Waste Management Act of Iran. The quantity of this waste produced in the studied power plant is about 20 tonnes year(-1). In the present investigation, the first to be carried out in Iran, seven composite samples of dewatered sludge from air heater washing wastewater treatment were subjected to investigation of the physical properties, chemical composition and leaching properties. The most likely pollutants that were of concern in this study were heavy and other hazardous metals (Cd, Co, Cr, Mn, Ni, Pb, Zn and V). The results revealed that mean pH, wet and dry density and moisture content of the waste were 6.31, 1532 kg m(-30, 1879 kg m(-3) and 15.35%, respectively. Magnetite, SiO2, P2O5, CaO, Al2O3 and MgO were the main constituents of the waste with a weight percentage order of 68.88, 5.91, 3.39, 2.64, 2.59 and 1.76%, respectively. The toxicity characteristic leaching procedure test results for some heavy and other hazardous metals showed that mean elemental concentrations of Cd, Co, Cr, Mn, Ni, Pb, V and Zn in leachate were 0.06, 1.55, 5.49, 36.32, 209.10, 0.58, 314.06 and 24.84 mg L(-1), respectively. According to the Waste Management Act of Iran this waste should be classified as hazardous and should be disposed of in accordance with hazardous waste disposal regulations.

Multi‐phase electro‐chemical catalytic oxidation of wastewater

AbstractThe removal of organic pollutants from synthetic wash wastewater by a combined multi‐phase electro‐catalytic oxidation method was evaluated using porous graphite as anode and cathode, and CuO–Co2O3–PO43− modified kaolin as catalyst. The synergic effect on COD removal was studied when integrating the electro‐chemical reactor with the effective modified kaolin in a single undivided cell; the results showed that higher COD removal efficiency was obtained than those obtained using the individual processes. Under optimal conditions of pH 3, 30 mA cm−2 current density, very effective reduction of organic pollutants was achieved with this combined electro‐chemical method. High removal efficiency (90%) of the chemical oxygen demand (COD) was obtained in 60 min in the treatment of simulated wash wastewater (anionic surfactant, sodium dodecyl benzene sulfonate [DBS]). This method was also applied to treat wastewater form paper‐making and resulted in a COD reduction of 84%. Based on the investigation, a possible mechanism of this combined electro‐chemical process was proposed. The pollutants in wastewater could be decreased by the high reactive OH• that were produced via the decomposition of electro‐generated H2O2 activated by the synergic effect of electro‐field and catalyst. The results indicate that the multi‐phase catalytic electro‐chemical oxidation process is a promising technique for wastewater treatment. Copyright © 2006 Society of Chemical Industry

Technical optimization of a batch olive wash wastewater treatment membrane plant

Technical optimization of a batch olive wash wastewater treatment membrane plant