Stem form is often used as a sawlog assortment criterion and has an important effect on lumber recovery and mechanical properties. Based on 7018 stems collected from the natural stands in 3 regions in eastern Canada, this study quantified the variations in stem form (taper, sweep and eccentricity) for five major commercial softwood species, viz., jack pine ( Pinus banksiana Lamb.), black spruce ( Picea mariana), white spruce ( Picea glauca), red spruce ( Picea rubens) and balsam fir ( Abies balsamea). The majority of the stems had a diameter at breast height (DBH) ranging from 10 to 32 cm and total tree height from 10 to 20 m. Stem taper and butt taper increased steadily from 0.38 to 1.75 cm/m and from 0.74 to 4.23 cm/m, respectively, with DBH increasing from 8 to 48 cm. Stem sweep and basal sweep ranged from 0.12 to 7.28 cm/m and from 0.12 to 9.85 cm/m, respectively, with mean values of 0.87 and 0.95 cm/m. There were no significant differences in stem sweep and basal sweep between DBH classes and both sweeps distributed over a wide range within DBH classes, species and regions. About 0.77% of the stems and 1.2% of the butt logs had seriously curved shapes (sweep >3.0 cm/m). Eccentricity (ratio of smaller diameter to larger diameter) at the breast height (0.96) was very close to 1. Balsam fir and jack pine had the best and worst stem forms, respectively, while stem forms in black spruce were in-between. Butt logs were most seriously curved in red spruce and most tapered in white spruce. Region C (mainly eastern Quebec and the Atlantic Provinces) produced stems with smaller butt taper, basal sweep and stem sweep and larger eccentricity compared with other regions in eastern Canada. Overall stems in eastern Canada have a good stem form in terms of taper, sweep and eccentricity. The evaluation of stem form provides valuable timber quality information for the wood industry to optimize wood processing as well as for forest managers to define appropriate silvicultural regimes to improve stem form and economic value.