Several faults in the Teruel and Jiloca grabens (Iberian Chain, NE Spain), particularly the targeted Concud fault, show evidences of recent, continuous activity, despite their scarce instrumental and historic seismic record.Three trenches are studied in two locations (central and southeastern sectors of the Concud fault, respectively). After comparing with previous works, we reconstruct a palaeoseismic succession with nine events distributed along a maximum time lapse bracketed between 81.6 and 14.0ka. This succession involves an average recurrence interval of 7.4±2.8ka, with individual interseismic periods between 4 and 11ka. The calculated coseismic displacements range from 0.6 to 2.7m, with an average value of 1.9m that results in a slip rate of 0.26mm/a. Due to the incomplete sedimentary record for Holocene times, we cannot affirm that the youngest event detected was actually the last one. We conjecture that some other events may have occurred during the period between 15.0 and 3.4ka.Temporal and spatial variations have been detected in palaeoseismic activity, specifically in the distribution of coseismic displacements. First, a non-steady slip rate is evidenced during Plio-Pleistocene times: a long-term tendency towards increasing slip rate is modulated in detail by the occurrence of minor cycles, as the sequence of increasing/decreasing activity recorded within the studied time window suggests. Secondly, an asymmetric distribution of coseismic slip along the fault trace is observed, paralleling the distribution of total fault throw, which shows an absolute maximum close to the southeastern tip. A combination of factors is proposed to explain this: branching of the main fault; dominant, remote-stress-driven slip towards N 220° E on the NW–SE fault segment; guided movement on the passive, NNW–SSE segment giving rise to an oblique roll-over monocline; and decoupling of the hanging-wall block owing to the transverse Los Mansuetos–Valdecebro fault zone.