Term Voltage Instability Research Articles

Emergency control measures against long term voltage instability

Emergency control measures against long term voltage instability

Monitoring Long Term Voltage Instability Due to Distribution and Transmission Interaction Using Unbalanced $\mu$ PMU and PMU Measurements

This paper extends the idea of the Thevenin equivalent into unbalanced 3{\phi} circuits and proposes a 3{\phi} long-term voltage stability indicator (VSI), that can identify critical loads in a system. Furthermore, in order to identify whether the voltage stability limit is due to the transmission network or a distribution network, a transmission-distribution distinguishing index (TDDI) is proposed. The novelty in the proposed indices is that they can account for the unbalance in the lines and loads, enabling them to use unbalanced phasor measurements naturally. This is supported by mathematical derivations and numerical results. A convex optimization formulation to estimate the 3{\phi} Thevenin equivalent using PMU & {\mu}PMU measurements is proposed, making it possible to calculate VSI and TDDI in an online model-free manner. Numerical simulations performed using co-simulation between Pypower and GridlabD are presented for the IEEE 9 bus and the 30 bus transmission networks combined with several modified IEEE 13 node and 37 node distribution networks. These case studies validate the proposed 3{\phi}-VSI and TDDI over a wide range of scenarios and demonstrate the importance of {\mu}PMU measurements in identifying the regions causing long term voltage instability.

Dynamic Optimization Based Reactive Power Planning to Mitigate Slow Voltage Recovery and Short Term Voltage Instability

Short term voltage stability poses a significant threat to system stability and reliability. This paper applies dynamic VAr injection to ensure short term voltage stability following a large disturbance in a power system with high concentration of induction motor loads. Decelerating and stalling of induction motor loads is considered to be the major cause of fault induced delayed voltage recovery (FIDVR) and short term voltage stability. If system dynamics are not taken into account properly, the proposed control solution may be an expensive over design or an under design that is not capable of eliminating FIDVR problems completely. In this work, the optimal amount and locations for installing dynamic reactive resources are found by control vector parameterization (CVP), a dynamic optimization approach. The efficiency and effectiveness of this approach is improved by utilizing results from trajectory sensitivity analysis, singular value decomposition and linear programming optimization. Dynamic optimization based on CVP approach is tested in an IEEE 162-bus system and a realistic large scale utility power system.