Tungsten-based coatings without TiC addition (TiC-free) and with 1.5 wt% TiC addition (TiC-doped) were fabricated by supersonic atmospheric plasma spraying (SAPS) technique, respectively. The as-sprayed coatings were then irradiated by laser. The results showed that the as-sprayed coatings were mainly composed of lamellar structure. TiC phase located mainly at lamellar gaps of the as-sprayed TiC-doped coating with a morphology of strip filled the gaps. The as-sprayed TiC-doped coating exhibited dense structure, lower porosity, reduced oxygen content and higher thermal conductivity as compared with the as-sprayed TiC-free coating. The as-irradiated coatings could be divided into remelted zone, un-remelted zone and/or mixing zone. Cracks were more easily formed in the as-irradiated TiC-free coating than in the as-irradiated TiC-doped coating. The stripped TiC phase in the as-sprayed TiC-doped coating changed into quasi-spherical/spherical ones in the remelted zone of the irradiated coating and distributed along the tungsten grain boundaries. The averaged tungsten grain size in the remelted zone of the as-irradiated TiC-doped coating was about 5.4 μm and that of the as-irradiated TiC-free coating was about 14.8 μm. There were about 96 wt% α(W) and about 4 wt% γ(W) existed in the remelted zone near the surface of the as-irradiated TiC-free coating. Only α(W) could be received in the remelted zone far from the surface of the as-irradiated TiC-free coating and the remelted zone of the as-irradiated TiC-doped coating. There were no obvious diffraction peaks for γ(W) could be indexed from the XRD patterns for the as-irradiated TiC-doped coating. The ability of the as-sprayed TiC-doped coating to resist laser irradiation was greater than the as-sprayed TiC-free coating, mainly attributing to the higher thermal conductivity of the as-sprayed TiC-doped coating and the refinement effect of TiC particles in the as-irradiated TiC-doped coating.