Sub-connected Architecture Research Articles

Energy-Efficient Hybrid Analog and Digital Precoding for MmWave MIMO Systems With Large Antenna Arrays

Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention baseband processing complexity. However, most hybrid precoding techniques consider a fully-connected architecture requiring a large number of phase shifters, which is also energyintensive. In this paper, we focus on the more energy-efficient hybrid precoding with sub-connected architecture, and propose a successive interference cancelation (SIC)-based hybrid precoding with near-optimal performance and low complexity. Inspired by the idea of SIC for multi-user signal detection, we first propose to decompose the total achievable rate optimization problem with non-convex constraints into a series of simple sub-rate optimization problems, each of which only considers one sub-antenna array. Then, we prove that maximizing the achievable sub-rate of each sub-antenna array is equivalent to simply seeking a precoding vector sufficiently close (in terms of Euclidean distance) to the unconstrained optimal solution. Finally, we propose a low-complexity algorithm to realize SICbased hybrid precoding, which can avoid the need for the singular value decomposition (SVD) and matrix inversion. Complexity evaluation shows that the complexity of SIC-based hybrid precoding is only about 10% as complex as that of the recently proposed spatially sparse precoding in typical mmWave MIMO systems. Simulation results verify the near-optimal performance of SIC-based hybrid precoding.

Energy-Efficient Transceiver Design for Hybrid Sub-Array Architecture MIMO Systems

Millimeter-wave (mmWave) communication operated in frequency bands between 30 and 300 GHz has attracted extensive attention due to the potential ability of offering orders of magnitude greater bandwidths combined with further gains via beamforming and spatial multiplexing from multi-element antenna arrays. mmwave system may exploit the hybrid analog and digital precoding to achieve simultaneously the diversity, array and multiplexing gain with a lower cost of implementation. Motivated by this, in this paper, we investigate the design of hybrid precoder and combiner with sub-connected architecture, where each radio frequency chain is connected to only a subset of base station antennas from the perspective of energy efficient transmission. The problem of interest is a non-convex and NP-hard problem that is difficult to solve directly. In order to address it, we resort to design a two-layer optimization method to solve the problem of interest by exploiting jointly the interference alignment and fractional programming. First, the analog precoder and combiner are optimized via the alternating-direction optimization method where the phase shifter can be easily adjusted with an analytical structure. Then, we optimize the digital precoder and combiner based on an effective multiple-input multiple-output channel coefficient. The convergence of the proposed algorithms is proved using the monotonic boundary theorem and fractional programming theory. Extensive simulation results are given to validate the effectiveness of the presented method and to evaluate the energy efficiency performance under various system configurations.