Subcarrier-multiplexed Signals Research Articles

Optical fibre transmission of a broadband subcarrier multiplexed signal using PTM techniques

Subcarrier multiplexing (SCM) is an attractive multiplexing technique to deliver broadband services over optical fibres. The majority of existing systems employ an analogue signal for optical transmission and therefore the performance of these systems are limited. This paper proposes to improve SCM system performance by converting the analogue SCM signal into a pulse time modulated signal for optical transmission. The pulse time modulation techniques investigated are pulse frequency modulation and square wave frequency modulation. System measurements and theoretical predictions were obtained and they are in close agreement. We have improved the dynamic range and optical power budget considerably, compared to conventional systems.

Asymptotic clipping noise distribution and its impact on M-ary QAM transmission over optical fiber

Performance analysis for a hybrid subcarrier-multiplexed (SCM) AM/QAM transmission over an optical fiber is presented. It is shown that the bit-error-rate (BER) of M-ary QAM in such hybrid systems can be significantly affected due to occasional laser of the SCM signal. Here we analytically determine the asymptotic distribution of the clipping noise by modeling it as a Poisson impulse train. The BER of M-ary QAM is then evaluated in terms of optical modulation indices of M-ary QAM and AM signals which in turn specify signal-to-noise ratio (SNR), impulsive index (clipping index) of the clipping noise, and power ratio of the Gaussian noise to the clipping noise. Numerical examples are given and compared with experimental data with reasonably good agreement for small SNR's. The results have application for estimating the BER's of digital signals for SCM analog/digital transmission over an optical fiber and for employing appropriate error correction codes and/or optimum receiver design for such environments. >

Overmodulation in subcarrier multiplexed video FM broad-band optical networks

The probability of an SCM (subcarrier multiplexed) signal falling outside the linear region of a laser diode is calculated in order to determine the overmodulation that may be practically employed for multichannel video distribution in single-octave SCM networks. The overmodulation is predicted as a function of the number of subcarriers in single-octave SCM systems supporting up to about 70 FM video channels, for SNRs (signal-to-noise ratios) of 47 dB (I/PAL), and 56 dB (M/NTSC). The RMS optical modulation index (OMI) is demonstrated to be a more useful performance parameter than the linear OMI in SCM systems carrying a large number of channels. A 47 dB weighted SNR (with 4 dB margin) is deemed sufficient for acceptable picture quality in cable distribution systems, whereas a 56 dB value would be required for long-distance point-to-point optical links. RMS OMI values of around 70 and 50, respectively, can be employed.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>