Creep results of a dispersion-strengthened nominal-composition Cu-2.5 vol.%Ti-2.5 vol.%Al alloy, and the adjustment of those results to existing creep models, are presented. The alloy was prepared by reaction milling; its microstructural characterization by transmission electron microscopy had been recently reported elsewhere. Creep tests were here performed at 773, 973 and 1123 K, under loads that produced steady-state creep rates between 9 × 10 −7 and 2 × 10 −4 s −1. Two deformation models, available in the literature, were considered: dislocation creep, where the strain rate is controlled by the dislocation-particle interaction within the grains, and diffusional creep, controlled by the interaction between grain-boundary dislocations and particles. In all creep experiments the alloy exhibited high values of the apparent stress exponent, as typical for dispersion-strengthened alloys. Through model adjustment, the operating creep mechanisms where determined: at 773 and 1123 K, creep is controlled by dislocation/particle interactions taking place in the matrix and in grain boundaries, respectively, while at the intermediate temperature of 973 K, controlling dislocation-particle interactions would occur both in the matrix and in grain boundaries.