Stages Of Rift Development Research Articles

Dominance of lateral over axial sedimentary fill in dryland rift basins

ABSTRACT Facies models for continental rift basins suggest longitudinal (axis-parallel) fluvial activity dominates sediment transport and deposition. In contrast, modern basins in the arid to semi-arid northern Basin and Range Province, USA, show axial drainage development to be characterized by short endorheic systems that contribute little to the basin fill. Mapping and calculation of the proportionate distribution of surficial facies of three representative basins at different stages of rift evolution show that basin fill is dominated by the deposits of transverse catchments, and axial fluvial deposits are restricted to a narrow corridor by the progradation of lateral systems. Drainage integration in these dryland rifts is limited by the moisture-stressed climate, with a resultant reduction in stream power, and the complex, tectonically-induced physiography, which limits potential drainage pathways. River systems that flow through multiple structural basins are rare, restricted to those systems with catchment headwaters lying outside the dryland climatic regime. These data imply that long-range, axial fluvial deposits should not automatically be included as a significant part of dryland rift sedimentary facies models. Sediment routing pathways in ancient dryland rift systems may be much shorter than commonly predicted, so affecting the spatial distribution of lithofacies. Climate, therefore, has a much stronger control on drainage and lithofacies at all stages of rift development than is generally stated.

Petroleum geology of the Melut Basin and the Great Palogue Field, Sudan

This paper overviews the framework, structural and petroleum geology aspects of the Melut rift Basin in Sudan. The data base is from mainly proprietary exploration work consisting of more than 20,000 km of seismic profiles, 2000 km 2 of 3D seismic, and more than 50 exploration wells. There have been more than 15 oil and oil and gas discoveries. The Melut Basin is a Meso-Cenozoic rift basin accompanied by the formation and development of the Central African Shear Zone (CASZ) on the pre-Cambrian crystalline and metomorphic basement of lower relief. Three stages of rift development and fracturing have been identified, stronger in the Early Cretaceous and Paleogene and weaker in the Late Cretaceous. Source rocks are the Lower Cretaceous lacustrine shales, whereas reservoirs and seals are both Paleogene and Upper Cretaceous. Dominant structural styles are large-scale anticlines in the Paleogene sequences and antithetic normal fault-blocks in the Upper Cretaceous and Paleogene. Heavy to light oils (8.87–61.5° API) and gas have been discovered in the Paleogene and only light oils and gas in the Upper Cretaceous pay zones. The primary pay zone in the Melut Basin is the Paleogene. The Great Palogue Field, with ultimate recoverable oil reserves of more than 900 million barrels, was discovered in the northern Melut Basin. The gentle slopes of each subbasin are favorable areas for petroleum accumulation and enrichment. The faulted anticlines within the Paleogene syn-rift sequences are the main trap types, whereas the antithetic fault-blocks of the Upper Cretaceous sequences are secondary.

Composition of Rift-Related Igneous and Sedimentary Rocks of the Keweenawan Supergroup in the Poersch No. 1, OZ-1, Finn, and Friederich Wells, Northeastern Kansas

A series of wells have been drilled up to a depth of 3,444 m (113,000 ft) into the midcontinent rift system (MRS) in northeastern Kansas. The age of a gabbro sill in the upper portion of the Precambrian rocks was determined to be 1,097.5 ± 3 Ma, and the magnetic polarity of the gabbro correlated to the lower Keweenawan rocks in the northern MRS (Van Schmus et al., 1990). The rocks below 2,259 m (7,411 ft) in the deepest well [Poersch no. 1, total depth 3,435 m (11,270 ft)] consist mostly of arkoses with subordinate amounts of shale, siltstone, and basalt. The rocks above 2,265 m (7,431 ft) in the Poersch well consist of basalt with minor siltstone, arkose, gabbro, and felsite. A proposed high-angle reverse fault could have juxtaposed the upper igneous rocks over the lower sedimentary rocks to produce a reversed stratigraphy. This would make the development of the southern MRS similar to that of the northern MRS. Thus, in the initial extensional phase of the MRS, broad subsidence coincided with abundant volcanism and little sediment production. Grabens formed in the later stages of rift development and were filled with abundant sedimentary rocks along with lesser volcanic rocks. The chemical characteristics of the basalts in the southern MRS are similar to those in the north. The southern basalts are subalkalic to alkalic and follow tholeiitic trends; a number of them are high-alumina basalts. Although there is a lot of scatter, Al2O3, Ni, and Cr concentrations decrease and Fe2O3, TiO2, K2O, rare earth elements, Ba, Hf, and Sc concentrations increase with decreasing Mg number. These trends are consistent with plagioclase, olivine, pyroxene, or spinel fractionation from primary basalts. One basalt could represent a primary magma because it has a high Mg number (0.68), high Ni (638 mg/kg) and Cr (233 mg/kg) concentrations, low incompatible element concentrations (e.g., La = 4.2 mg/kg), and a slight positive Eu anomaly. This possible primary magma could have formed by partial melting (20-25%) of an undepleted spinel peridotite at 30-40 km depth. Most basalts have not been contaminated by crustal rocks or silicic magmas. The mineralogy, chemical composition, and U-Pb geochronology of detrital zircons of the arkoses, siltstones, and shales are consistent with their derivation from the surrounding granitoid highlands with little or no input from the basalts. Even siltstones and arkoses within the mostly basaltic sequences are derived mostly from the granitoids, although the siltstones may have some input from the basalts (e.g., higher Ni concentration than the sandstones).

Early Cretaceous rifts of Western and Central Africa: an overview

The structure and evolution of Early Cretaceous rift basins in Western and Central Africa are described. Two stages of rift development and fracturing have been identified: (1) from Neocomian to Early Aptian roughly E-W and NW trending troughs (Upper Benue, N Cameroon, S Chad, Sudan etc.) opened in response to a submeridian extensional regime in Central Africa while in Western Africa the N-S trending transsaharian fault zone acted as a sinistral wrench; (2) from Middle Aptian to Late Albian large northwest trending troughs (E Niger, Sudan, Sirte, etc.) opened in response to a northeast extensional regime while the Central African fault zone (from Benue to Sudan) exhibited strike-slip movements, generating pull-apart basins. These rift and fracture systems delimit three large blocks within the African plate: a Western block, an Arabian-Nubian block and an Austral block. The Arabian-Nubian block tends to separate from the two other blocks, migrating towards the north during the first stage of basin development and then towards the NE during the second stage. The opening of the Atlantic Ocean was the dominant driving force for the Western and Austral blocks while the Arabian-Nubian block probably moved in response to the opening of the Indian Ocean and to the evolution of the Tethyan margin.