Electric vehicles (EVs) are one of the the promising solutions for the environmental issues such as carbon emission and global warming. The high voltage traction battery in EVs is charged from utility grid by an EV charger. The Society of Automotive Engineers (SAE) standardize EV charges into two categories on-board chargers and off-board chargers. Usually, the on-board chargers are located inside the vehicle whereas, off-board chargers are not mounted on the vehicle. For onboard chargers, size and power density of charger become a prior matter of concern. The only way to reduce the size of a converter and thereby increase the power density is to operate power electronic conversion system (PECS) at very high switching frequency (HSF) resulting in reduced size of magnetic component in the charger configuration. However, HSF operation may lead to a high electromagnetic interference (EMI), loss in switch and switch duty. The work in this paper is focused on the development of high frequency bi-directional DC-DC converter (BD2C) stage priory used in on-board chargers due to distributed sources of energy as well as to manage the power distribution in the configuration. The power electronic BDCs are derived from boost and buck unit. The boost derived converter are current fed converters and offers advantages in terms of inherent voltage gain, short circuit protection and lower input current ripple. The voltage spikes across switches, high rated device selection, hard switching, snubber and auxiliary circuit requirements are some of the undesirable factors. This occurrence happened due to unbalance power transfer by the power electronics converter. Similarly, voltage fed converter offers good voltage control during power transfer.