SPR-based Method Research Articles

Determination of Binding Constant and Stoichiometry for Antibody-Antigen Interaction with Surface Plasmon Resonance

A surface plasmon resonance (SPR) biosensor technology has recently been applied biochemically and clinically to the study of immunologic recognition and the evaluation of binding parameters for various interactions between antibodies (Abs) and antigens (Ags) at liquid-solid interface. The simple interaction between hapten and Ab fragment, e.g., variable single-chain fragment and antigenbinding fragment, can be described sufficiently by a 1:1 stoichiometry in SPR. However, the determination of the binding constant of an anti-protein Ab is usually complicated by the multivalence of the protein Ag. The SPR-based method enables direct determination of binding constants for a variety of specific Ab-Ag interactions in real-time. It also allows estimation of the binding stoichiometry and binding ratio for low-, intermediate-, and high-affinity Ab-Ag interaction systems. The present review is designed to indicate the theoretical background of SPR-based biosensor technology as well as to present the great variety of measurement modes of interaction kinetics that can be performed with these techniques. Quantitative aspects of the Ab-Ag interaction kinetics are reviewed, focusing especially on mono- and multi-valent Ab-Ag interaction modes using a SPR biosensor. Four model binding systems developed recently for use with SPR biosenser are described with principles and examples: (i) one to one interaction mode, (ii) nonequivalent two-site interaction mode, (iii) multiple equivalent-site interaction mode and (iv) multisite interaction mode. This article closes with two descriptions of the determinations of the binding stoichiometry and maximum binding ratio of Ab-Ag interactions.

Surface Plasmon Resonance Analysis of Antifungal Azoles Binding to CYP3A4 with Kinetic Resolution of Multiple Binding Orientations

The heme-containing cytochrome P450s (CYPs) are a major enzymatic determinant of drug clearance and drug-drug interactions. The CYP3A4 isoform is inhibited by antifungal imidazoles or triazoles, which form low-spin heme iron complexes via formation of a nitrogen-ferric iron coordinate bond. However, CYP3A4 also slowly oxidizes the antifungal itraconazole (ITZ) at a site that is approximately 25 A from the triazole nitrogens, suggesting that large antifungal azoles can adopt multiple orientations within the CYP3A4 active site. Here, we report a surface plasmon resonance (SPR) analysis with kinetic resolution of two binding modes of ITZ, and the related drug ketoconazole (KTZ). SPR reveals a very slow off-rate for one binding orientation. Multiphasic binding kinetics are observed, and one of the two binding components resolved by curve fitting exhibits "equilibrium overshoot". Preloading of CYP3A4 with the heme ligand imidazole abolishes this component of the antifungal azole binding trajectories, and it eliminates the conspicuously slow off-rate. The fractional populations of CYP3A4 complexes corresponding to different drug orientations can be manipulated by altering the duration of the pulse of drug exposure. UV-vis difference absorbance titrations yield low-spin spectra and K(D) values that are consistent with the high-affinity complex resolved by SPR. These results demonstrate that ITZ and KTZ bind in multiple orientations, including a catalytically productive mode and a slowly dissociating inhibitory mode. Most importantly, they provide the first example of a SPR-based method for the kinetic characterization of binding of a drug to any human CYP, including mechanistic insight not available from other methods.

Ordered anchored cavities at work: a new and rapid SPR-based method for the detection of trace amounts of Cs+

Fourier transform-surface plasmon resonance (FT-SPR) using Au(111) chips modified by a 1,3-alternate calix[4]arene-crown-6 derivative is proposed as a method to detect Cs+ at the ppb level.

Surface plasmon resonance detection of interactions between peptide fragments of N-telopeptide and its monoclonal antibodies.

As populations age, osteoporosis is becoming an important public health care problem. Urinary level of the cross-linked N-telopeptide of type I collagen has been reported to be a sensitive marker of bone resorption. Recently, we synthesized and characterized 10 overlapping peptides covering the N-telopeptide of alpha-2 type I collagen and reported their relative binding response to anti-type I collagen cross-linked N-telopeptide (NTX) antibodies determined by a competitive-inhibition enzyme-linked immunosorbent assay (ELISA). In this study, we design an assay based on the surface plasmon resonance (SPR) technology to detect binding interaction of each peptide fragment of NTX with the anti-NTX monoclonal antibodies. Anti-NTX monoclonal antibodies were immobilized on the surface of sensor chip by amine-coupling procedure. Serial dilutions of each peptide were prepared and injected separately onto the antibodies-immobilized sensor chip. The real-time association and dissociation interactions of each peptide were detected and reported as sensorgrams. Binding response of each peptide to the monoclonal antibodies was determined, and the SPR results were compared with the ELISA results. We demonstrate that the trends of binding potency of peptide fragments detected by SPR are in good correlation to the results obtained by ELISA, indicating that our developed SPR-based method can be further applied to detect the NTX fragments in urine and to monitor the bone loss in humans. The potent peptide fragments identified by both assays are promising for further preparation of specific monoclonal antibodies in order to develop bioassays for bone loss in humans.

Surface Plasmon Resonance Study of RNA–Aminoglycoside Interactions

An increasing number of small molecules with different structures have been discovered that bind to RNA. With the advanced techniques available to elucidate RNA structures and probe RNA–small molecule interactions, the underlying recognition principles regarding molecular details are just beginning to be revealed. For rational design of selective RNA binders, detailed knowledge of structure–affinity relationships between RNA and small molecules is required, as well as analysis of the binding specificity of various RNA sequences. Several methods have been used to investigate the binding between RNA and small molecules. Surface plasmon resonance (SPR) biosensor has been used to measure RNA–small molecule interactions and provides real-time monitoring without a labeling requirement. Although the SPR-based method has been applied to monitor macromolecular interactions, only more recently, with improved instrument detection accuracy, bindings between small molecules and macromolecules can be successfully monitored by SPR. This chapter focuses on describing procedures performed in the SPR binding assay, using aminoglycoside–bacterial ribosome 16S A-site binding as an example. The methods of data analysis to derive the equilibrium constant and binding stoichiometry are also discussed in the chapter.

Determination of active concentrations and association and dissociation rate constants of interacting biomolecules: an analytical solution to the theory for kinetic and mass transport limitations in biosensor technology and its experimental verification.

Accurate determination of kinetic rate constants for interacting biomolecules requires knowledge of the active concentrations of the participating molecules. Also, in other biomedical and clinical applications, sensitive, precise and accurate methods are needed to determine the concentration of biologically active molecules, which frequently constitute only a fraction of the total molecular pool. Here we report a novel development of the approach to determining active concentrations based on surface plasmon resonance (SPR) technology. The method relies on changes in binding rates with varying flow rates under conditions of partial mass transport, and does not require standards of known concentrations, given that the molecular mass of the molecule of interest is known. We introduce an analytical solution to the differential equations describing the formation of a 1:1 bimolecular complex, taking into account both the association and dissociation reactions, under partial mass transport limitations. This solution can be used in global fitting to binding curves obtained at different flow rates. The accuracy, precision, and sensitivity of this approach were determined in experiments involving binding of tyrosine-phosphorylated recombinant proteins to anti-phosphotyrosine antibodies, where the active concentration could be determined independently by in vitro phosphorylation with (33)P. There was an excellent agreement between the active concentrations determined by the analytical SPR-based method and by determination of the level of radioactivity of the phosphorylated protein. The SPR-based method allows determination of protein concentrations at picomolar levels. A procedure for accurate determinations of association and dissociation rate constants, based on the analytical solution of the mass transport and binding theory, is outlined.