Soil Moisture And Ocean Salinity Images Research Articles

Deriving VTEC Maps from SMOS Radiometric Data

In this work, a new methodology is proposed in order to derive vertical total electron content (VTEC) maps from the radiometric measurements of the Soil Moisture and Ocean Salinity (SMOS) mission as an alternative approach to those based on external databases and models. This approach uses spatiotemporal filtering techniques with optimized filters to be robust against the thermal noise and image reconstruction artifacts present in SMOS images. It is also possible to retrieve the Faraday rotation angle from the recovered VTEC maps in order to correct the effect that it causes in the SMOS brightness temperatures.

A New Direct Sun Correction Algorithm for the Soil Moisture and Ocean Salinity Space Mission

The interferometric measurements provided by the Soil Moisture and Ocean Salinity (SMOS) satellite are contaminated by solar radiations due to a quasi-permanent presence of the Sun in the field of view of the instrument. A correction algorithm is developed and implemented in the SMOS image reconstruction processor to remove the contribution of these radiations. Since the Sun is seen under an angle much smaller than the angular resolution of SMOS, this algorithm assimilates the Sun disc to a single source located at its center. However, strong residuals persist in the retrieved images mainly due to the presence of different distributed smaller sources of brightness in the Sun disc. Thus, the performance of the algorithm degrades rapidly as soon as the dominant source is far from the center of the disc. This behavior shows the limitation of the algorithm and its strong dependencies to the position of the Sun. In this article, we propose two other algorithms to account for the solar radiations. The first one is an iterative optimization algorithm based on estimating the position of the dominant source of brightness inside the Sun disc. The second algorithm is based on estimating the contribution of the different sources of brightness within the Sun disc using an oversampled grid by solving a constrained least square optimization problem with an explicit solution.

Spatial Correlations in SMOS Antenna: The Role of Effective Point Spread Functions

Since its launch in 2009, the European Space Agency mission Soil Moisture and Ocean Salinity (SMOS) has provided valuable information on soil moisture, sea surface salinity data, and other geophysical variables. Due to its innovative instrument, an L-band 2-D synthetic aperture interferometric radiometer, SMOS is able to provide high-resolution L2 data (as compared with other L-band missions). However, SMOS processing is complex, giving rise to the emergence of some unexpected biases. In this paper, we have analyzed the spatial structure of two-point correlations owing to the SMOS synthetic antenna, finding that they are not negligible. Those correlations can be characterized by means of effective point spread functions (PSFs). This paper indicates that the SMOS PSF matrix can be computed in a fast way from measured data without the need for any model or auxiliary data. Furthermore, this matrix can be described in terms of a convolution kernel. The knowledge of that convolution kernel can be used to improve the quality of the SMOS image and to assess the effect of changes of processing procedures, including calibration methods.

Nodal Sampling: A New Image Reconstruction Algorithm for SMOS

Soil moisture and ocean salinity (SMOS) brightness temperature (TB) images and calibrated visibilities are related by the so-called G-matrix. Due to the incomplete sampling at some spatial frequencies, sharp transitions in the TB scenes generate a Gibbs-like contamination ringing and spread sidelobes. In the current SMOS image reconstruction strategy, a Blackman window is applied to the Fourier components of the TBs to diminish the amplitude of artifacts such as ripples, as well as other Gibbs-like effects. In this paper, a novel image reconstruction algorithm focused on the reduction of Gibbs-like contamination in TB images is proposed. It is based on sampling the TB images at the nodal points, that is, at those points at which the oscillating interference causes the minimum distortion to the geophysical signal. Results show a significant reduction of ripples and sidelobes in strongly radio-frequency interference contaminated images. This technique has been thoroughly validated using snapshots over the ocean, by comparing TBs reconstructed in the standard way or using the nodal sampling (NS) with modeled TBs. Tests have revealed that the standard deviation of the difference between the measurement and the model is reduced around 1 K over clean and stable zones when using NS technique with respect to the SMOS image reconstruction baseline. The reduction is approximately 0.7 K when considering the global ocean. This represents a crucial improvement in TB quality, which will translate in an enhancement of the retrieved geophysical parameters, particularly the sea surface salinity.

A Kurtosis-Based Approach to Detect RFI in SMOS Image Reconstruction Data Processor

The Soil Moisture and Ocean Salinity (SMOS) mission is a European Space Agency project aimed to observe two important geophysical variables, i.e., soil moisture over land and ocean salinity by L-band microwave imaging radiometry. This work is concerned with the contamination of the SMOS data by radio-frequency interferences (RFIs), which degrades the performance of the mission. In this paper, we propose an approach that detects if a given snapshot is contaminated, or not, by RFI. This approach is based on evaluating the kurtosis of each snapshot or data set, using all interferometric measurements provided by the instrument. The obtained kurtosis is considered as an indicator on how much the snapshot is polluted by RFI, thus allowing the user to decide on whether to keep or discard it.

RFI Detection Algorithm: Accurate Geolocation of the Interfering Sources in SMOS Images

The Soil Moisture and Ocean Salinity (SMOS) satellite is strongly affected by radio-frequency interference (RFI). A detection algorithm has been developed to accurately obtain the coordinates of the interfering source emitters from the SMOS images. The results obtained from this detection algorithm are regularly used to locate the on-ground sources of interference. This has allowed the identification and termination of over 200 RFI sources observed by SMOS. In the majority of cases, the accuracy of the coordinates provided was better than 4 km, which is a very important achievement considering that SMOS spatial resolution is larger than 35 km and that the contamination of a single RFI can extend to several thousands of kilometers in some cases.

SMOS Radiometer in the 1400–1427-MHz Passive Band: Impact of the RFI Environment and Approach to Its Mitigation and Cancellation

The Soil Moisture and Ocean Salinity (SMOS) radiometer operates within the Earth Exploration Satellite Service passive band at 1400-1427 MHz. Since its launch in November 2009, SMOS images are strongly impacted by radio frequency interference (RFI). So far RFI sources distributed worldwide have been detected. Up to 42% of these RFIs could be suppressed thanks to the co-operation of the National Spectrum Management Authorities. Some of the strongest RFI sources might mask other weaker sources underneath, hence it is expected the total number of RFI detected may increase as strong ones are progressively identified and switched off. Most RFIs are located in Asia and Europe, which together hold ~73% of the active sources and of the strongest interference. The areas affected by RFI may experience either an underestimation in the retrieved values of soil moisture and ocean salinity or data loss, with the associated detrimental impact on the scientific return. ESA and the teams participating in SMOS mission have put in place different strategies to alleviate this RFI situation.

SMOS Calibration and Instrument Performance After One Year in Orbit

This paper summarizes the rationale for the European Space Agency's Soil Moisture and Ocean Salinity (SMOS) mission routine calibration plan, including the analysis of the calibration parameter annual variability, and the performances and stability of SMOS images after one year of data. SMOS spends 1.68% of the total observation time in calibration. The instrument performs well within expectations with regard to accuracy and radiometric sensitivity, although spatial ripples are present in SMOS images. Several mechanisms are currently used or under investigation to mitigate this problem. Also, a loss antenna model has recently been introduced to correct for physical temperature-induced effects. This antenna model successfully corrects observed orbital variations, but has difficulties in correcting brightness temperature long-term drifting, as assessed using relatively well-known targets other than the external calibration region-cold space.

Minimization of Image Distortion in SMOS Brightness Temperature Maps Over the Ocean

Soil Moisture and Ocean Salinity (SMOS) brightness temperature synthesized images are obtained after a comprehensive error correction procedure that takes into account both on-ground and in-flight calibration measurements. However, the final images are still contaminated by small, although nonnegligible, spatial errors: the so-called pixel bias. Since spatial errors in the 2-D SMOS images are not zero mean along track, these errors produce clearly visible artifacts aligned to this direction. Fortunately, spatial errors have been found to be very stable and can be minimized once the image distortion pattern is properly measured by observing a target at a uniform brightness temperature distribution. This letter describes the procedure to compute a multiplicative mask that largely reduces spatial errors over the ocean. Preliminary results to assess the mask performance are also presented by computing the reduction of the rms spatial error for a number of targets selected to have significant temporal and geographical diversity.

Downscaling SMOS-Derived Soil Moisture Using MODIS Visible/Infrared Data

A downscaling approach to improve the spatial resolution of Soil Moisture and Ocean Salinity (SMOS) soil moisture estimates with the use of higher resolution visible/infrared (VIS/IR) satellite data is presented. The algorithm is based on the so-called “universal triangle” concept that relates VIS/IR parameters, such as the Normalized Difference Vegetation Index (NDVI), and Land Surface Temperature (Ts), to the soil moisture status. It combines the accuracy of SMOS observations with the high spatial resolution of VIS/IR satellite data into accurate soil moisture estimates at high spatial resolution. In preparation for the SMOS launch, the algorithm was tested using observations of the UPC Airborne RadIomEter at L-band (ARIEL) over the Soil Moisture Measurement Network of the University of Salamanca (REMEDHUS) in Zamora (Spain), and LANDSAT imagery. Results showed fairly good agreement with ground-based soil moisture measurements and illustrated the strength of the link between VIS/IR satellite data and soil moisture status. Following the SMOS launch, a downscaling strategy for the estimation of soil moisture at high resolution from SMOS using MODIS VIS/IR data has been developed. The method has been applied to some of the first SMOS images acquired during the commissioning phase and is validated against in situ soil moisture data from the OZnet soil moisture monitoring network, in South-Eastern Australia. Results show that the soil moisture variability is effectively captured at 10 and 1 km spatial scales without a significant degradation of the root mean square error.