The conditions of production and the most relevant directions of development of technology and equipment of cold rolling mills for the production of thin flat rolled steel are investigated, analyzed and summarized. A comparative analysis of cold rolling technology is carried out, which is implemented in continuous and reversed modes of mill. The technological limitations and criteria for the development of deformation modes on cold rolling strip mills, which allow to expand the assortment towards a smaller thickness, are given. A method for determining the thickness is proposed, and a series of thicknesses of thin (1.5-1.8 mm) hot-rolled break-down are recommended for the production of tinplate of single rolling and thin strips of high quality. The method of calculation schedule drafting on a specific mill is developed. The technique of determination of the smallest thickness of a strip on a concrete mill is presented, taking into account the influence of rigidity of the working cage and features of the force load of the roller node with a decrease in the thickness and width of the strip. The use of the above materials allows to select and justify the optimal variant of cold band rolling technology, as well as to develop rational deformation modes that ensure the implementation of the cold rolling process with maximum efficiency, given the desired range and the required volume of thin cold-rolled sheet steel or tinplate. As a result of taking into account the features of the force interaction of the thin strip with the rolls during cold rolling and the rigidity of the working stands of the mill, the accuracy and reliability of determining the parameters are increased, it opens additional possibilities for expanding the range of cold rolling mills towards smaller thicknesses.