High-temperature Fourier transform infrared (HT-FTIR) spectroscopy was used to characterize the deprotonation process of synthetic potassic-ferro-richterite of composition A ( K 0 . 90 Na 0 . 07 ) B ( Ca 0 . 54 Na 1 . 46 ) C ( Fe 4 . 22 2 + Fe 0 . 78 3 + ) T Si 8 O 22 W ( OH 1 . 70 O 0 . 30 2 − ) . Unpolarized single-crystal spectra were collected both in situ and on quenched samples, and heating experiments were conducted in air, at a rate of 10 °C/min. The room- T spectrum measured before annealing shows a main band at 3678 cm −1 and a minor band at 3622 cm −1 ; these are assigned to local configurations involving Fe 2+ at M (1) M (1) M (3) and facing a filled and an empty alkali-site, respectively. At 400 °C, a new band grows at 3656 cm −1 ; this is the most intense feature in the pattern at 450 °C. At T ≥ 500 °C, all peaks decrease drastically in intensity, and finally disappear at T > 600 °C. The total absorbance measured in situ increases significantly in the 25 T T range. This feature is consistent with an increase of the absorption coefficient (e) with T , the reason for which is still unclear. However, this feature has significant implications for the quantitative use of FTIR data in HT experiments. Examination of the relevant OH-stretching bands shows that iron oxidation occurs preferentially at the M (1,3) sites associated with occupied A sites. The deprotonation temperature indicated by FTIR for single-crystals is around 100 °C higher that that obtained by HT-X-ray diffraction (XRD) on single crystal by Oberti et al. (2016), whereas that obtained by HT-XRD on powders is intermediate. This unexpected observation can be explained by considering that: (1) the iron oxidation process, which is coupled to deprotonation and is probed by XRD, occurs preferentially at the crystal surface where it is triggered by the availability of atmospheric oxygen; (2) the proton diffusion, probed by FTIR, is slower that the electron diffusion probed by XRD; thus, the temperature shift may be explained by a much longer escape path for H in single-crystals than in powders. These results suggest that possible effects due to crystals size should be carefully considered in HT experiments done on Fe-rich silicates.