Silicon Photomultiplier Readout Research Articles

ASIC development for SiPM readout

The design of CMOS front-end electronics suitable for Silicon Photo-Multipliers (SiPM) is described in this paper, starting with the specification of an accurate electrical model of the detector and its experimental validation. A novel current-mode solution is proposed for the preamplifier and the discriminator, to cope with the large dynamic range and the extremely fast rise time of the detector signal. Experimental results achieved from front-end prototypes designed according to this current-mode approach demonstrate its effectiveness: dynamic range of the order of 50 pC and timing accuracy of the electronics alone of about 30 ps have been measured.

Scintillator tile hadron calorimeter with novel SiPM readout

The CALICE collaboration is presently constructing a test hadron calorimeter (HCAL) with 7620 scintillator tiles readout by novel photo-detectors—Silicon Photomultipliers (SiPMs). This prototype is the first device which uses SiPMs on a large scale. We present the design of the HCAL and report on measured properties of more than 10 000 SiPMs. We discuss the SiPM efficiency, gain, cross-talk, and noise rate dependence on bias voltage and temperature, including the spread in these parameters. We analyze the reasons for SiPM rejection and present the results of the long-term stability studies. The first measurements of the SiPM radiation hardness are presented. We compare properties of SiPM with the properties of similar devices, MRS APD and MPPC. A possibility to make the tiles thinner and to read them out without WLS fibers has been studied.

A high-granularity plastic scintillator tile hadronic calorimeter with APD readout for a linear collider detector

We report upon the performance of an analog hadron calorimeter prototype, where plastic scintillator tiles are read out with wavelength-shifting fibers coupled to avalanche photodiodes. This prototype configuration has been tested using a positron beam at DESY with energies between 1 and 6 GeV. We present different detector calibration methods, show measurements for noise, linearity, and energy resolution and discuss gain monitoring with an LED system. The results are in good agreement with our simulation studies and previous measurements using silicon photomultiplier readout.