This study aims to understand the effect of additive manufacturing (AM) on design fixation. Whereas previous research illustrates the positive aspects of AM, the overarching hypothesis of this work is that it might also have negative effects with respect to conventional manufacturability. In this work, participants from two groups, a design for conventional manufacturing (DfCM) group, and a design for additive manufacturing (DfAM) group, were asked to design a basic product. Then, a second iteration of the design asked both groups to design for conventional processes, and to include subtractive and formative methods like machining and casting, respectively. Findings showed that the DfAM fixated on nonproducible manufacturing features and produced harder to conventionally manufacture designs, even when told specifically to DfCM. There was also evidence that the complex designs of the DfAM group limited their modeling success and seemed to encourage them to violate more design constraints. This study draws attention to the negative effect of AM knowledge on designers and provides motivation for treatment methods. This is important if AM is used in prototyping or short run production of parts that are slated for conventional manufacturing later. The issue of design fixation is not a problem if AM is the final manufacturing method—a more common practice nowadays. This work suggests that one should consider the possibility of fixation in design environments where AM precedes larger volume conventional manufacturing.
Read full abstract