AbstractThe current paper presents an innovative form of the cold‐formed U‐shape steel encasing concrete composite beam (CUCB). The suggested CUCB consists of a cold‐formed U‐shaped steel encasing plain concrete beam which are connected to each other using continuous transversal threaded stud bolts. The experimental program consisted of eight beam specimens tested in the four‐point bending set‐up. One of them was a normal reinforced concrete beam and considered as a reference specimen while the remaining specimens were CUCB specimens without ordinary flexural and shear reinforcement. Four parameters were studied in this paper: (i) the thickness of the U‐shaped steel, (ii) the spacing between the stud bolts, (iii) the arrangement of the bolts, and (iv) the number of the bolt's rows. Results indicated an overall improvement in the load‐carrying capacity and stiffness of most CUCB specimens in comparison with the reference specimen. It was found that the using of three rows of bolts can significantly improve the ductility and toughness of the CUCB specimen in comparison with two rows of bolts. On the contrary, an increase in the bolt spacing entails a decrease in the CUCB specimens' toughness.