Semiconductor Disk Laser Research Articles

Intracavity Raman conversion of a red semiconductor disk laser using diamond.

We demonstrate a diamond Raman laser intracavity-pumped by a red semiconductor disk laser (~675 nm) for laser emission at around 740 nm. Output power up to 82 mW of the Stokes-shifted field was achieved, limited by the available pump power, with an output coupling of 1.5%. We also report wavelength tuning of the diamond Raman laser over 736 - 750 nm.

Dual-comb modelocked laser.

In this paper we present the first semiconductor disk laser (SDL) emitting simultaneously two collinearly overlapping cross-polarized gigahertz modelocked pulse trains with different pulse repetition rates. Using only a simple photo detector and a microwave spectrum analyzer directly down-converts the frequency comb difference from the optical to the microwave frequency domain. With this setup, the relative carrier-envelope-offset (CEO) frequency can be accessed directly without an f-to2f interferometer. A very compact design is obtained using the modelocked integrated external-cavity surface emitting laser (MIXSEL) which is part of the family of optically pumped SDLs and similar to a vertical external cavity surface emitting laser (VECSEL) but with both gain and saturable absorber integrated into the same semiconductor wafer (i.e. MIXSEL chip). We then simply added an additional intracavity birefringent crystal inside the linear straight cavity between the output coupler and the MIXSEL chip which splits the cavity beam into two collinear but spatially separated cross-polarized beams on the MIXSEL chip. This results in two modelocked collinear and fully overlapping cross-polarized output beams with adjustable pulse repetition frequencies with excellent noise performance. We stabilized both pulse repetition rates of the dual comb MIXSEL.

Z-scan measurements of the nonlinear refractive index of a pumped semiconductor disk laser gain medium

We measure the nonlinear refractive index of an antiresonant 1050 nm semiconductor disk laser (SDL) gain medium using a reflection-type z-scan system, with a 1064 nm, 10-ps-pulse laser as a probe, and a fiber-coupled 808 nm diode pump laser for carrier injection. Empirically, the nonlinear refractive index is found to depend approximately linearly on applied pump intensity, having a value of −1.5(0.2) × 10−12 cm2/W at zero excitation but increasing to take on positive values at typical SDL operating conditions. The focal lengths of corresponding Kerr lenses calculated using typical SDL pulse intensities and spot sizes are sufficiently short to be comparable to SDL cavity mirrors, implying that Kerr lens modelocking may be responsible for the behavior described in recent reports of self-mode-locked SDLs.

Less Heat — More Power

AbstractWe demonstrate a diode laser pumped semiconductor disk laser (SDL) at 2 μm wavelength of increased efficiency. By employing a novel pumping concept at a wavelength of 1470 nm, we optimize the power conversion efficiency of the 2 μm SDL. This is exemplarily shown for an SDL with an output power of over 20 W in continuous wave operation. This sets a new benchmark regarding efficiency and output power for these SDLs.

High performance wafer-fused semiconductor disk lasers emitting in the 1300 nm waveband

We report for the first time on the performance of 1300 nm waveband semiconductor disc lasers (SDLs) with wafer fused gain mirrors that implement intracavity diamond and flip-chip heat dissipation schemes based on the same gain material. With a new type of gain mirror structure, maximum output power values reach 7.1 W with intracavity diamond gain mirrors and 5.6 W with flip-chip gain mirrors, using a pump spot diameter of 300 µm, exhibiting a beam quality factor M(2)< 1.25 in the full operation range. These results confirm previously published theoretical modeling of these types of SDLs.

Self-mode-locking semiconductor disk laser.

The development of mode-locked semiconductor disk lasers received striking attention in the last 14 years and there is still a vast potential of such pulsed lasers to be explored and exploited. While for more than one decade pulsed operation was strongly linked to the employment of a saturable absorber, self-mode-locking emerged recently as an effective and novel technique in this field - giving prospect to a reduced complexity and improved cost-efficiency of such lasers. In this work, we highlight recent achievements regarding self-mode-locked semiconductor devices. It is worth to note, that although nonlinear effects in the active medium are expected to give rise to self-mode-locking, this has to be investigated with care in future experiments. However, there is a controversy whether results presented with respect to self-mode-locking truly show mode-locking. Such concerns are addressed in this work and we provide a clear evidence of mode-locking in a saturable-absorber-free device. By using a BBO crystal outside the cavity, green light originating from second-harmonic generation using the out-coupled laser beam is demonstrated. In addition, long-time-span pulse trains as well as radiofrequency-spectra measurements are presented for our sub-ps pulses at 500 MHz repetition rate which indicate the stable pulse operation of our device. Furthermore, a long-time-span autocorrelation trace is introduced which clearly shows absence of a pedestal or double pulses. Eventually, a beam-profile measurement reveals the excellent beam quality of our device with an M-square factor of less than 1.1 for both axes, showing that self-mode-locking can be achieved for the fundamental transverse mode.

Ultrafast nonequilibrium carrier dynamics in semiconductor laser mode locking

Semiconductor disk lasers have been shown to be ideal as wavelength-agile, high-brightness sources for producing high average power under various pulsed mode-locking scenarios. Systematic microscopic modeling reveals that ultrafast nonequilibrium kinetic hole burning in electron/hole carrier distributions dictates the outcome of femtosecond duration mode-locked pulse formation. The existence of a large reservoir of unsaturated carriers within the inverted distributions leads to the emergence of multiple pulse waveforms (not necessarily harmonically mode-locked pulse trains) that inefficiently draw on these carrier reservoirs. The concept of gain is no longer meaningful in this limit, and the dynamical inversion of electrons and holes primarily in the active medium establishes the final dynamical state of the system. The simulation results explain much of the generic behavior observed in key recent experiments and point to the difficulty of pushing semiconductor mode-locked lasers to pulse durations below 100 fs.

Growth and characterization of ZnCdMgSe-based green light emitters and distributed Bragg reflectors towards II-VI based semiconductor disk lasers

We report the structural and optical properties of molecular beam epitaxy grown II–VI semiconductor multiple quantum well (MQW) structures and distributed Bragg reflector (DBR) on InP substrates for application in developing optically-pumped semiconductor disk lasers (SDLs) operating in the green spectral range. One sample was grown directly on an InP substrate with an InGaAs buffer layer, while another had a 5-period ZnCdMgSe-based DBR grown on the InGaAs/InP substrate. X-ray diffraction and scanning electron microscopy measurements revealed sharp superlattice peaks and abrupt layer interfaces, while steady-state photoluminescence measurements demonstrated surface emission between 540–570 nm. Under pulsed excitation both samples exhibited features of amplified spontaneous emission (ASE) or stimulated emission, accompanied by luminescence lifetime shortening. The sample with the DBR showed higher surface luminescence and the onset of ASE at lower pump power. To further explore the design and performance of a ZnCdMgSe-based DBR, a 20-period DBR was grown and a reflectivity of 83% was obtained at ∼560 nm. We estimate that a DBR with ∼40 periods would be needed for optimal performance in a SDL using these materials. These results show the potential of II–VI MQW structures on InP substrates for the development of SDLs operational in the green–yellow wavelength range.

All quantum dot mode-locked semiconductor disk laser emitting at 655 nm

We present a semiconductor disk laser mode-locked by a semiconductor saturable absorber mirror (SESAM) with emission in the red spectral range. Both the gain and the absorber structure are fabricated by metal-organic vapor-phase epitaxy in an anti-resonant design using quantum dots as active material. A v-shaped cavity is used to tightly focus onto the SESAM, producing pulses with a duration of about 1 ps at a repetition rate of 852 MHz.

High-power flip-chip semiconductor disk laser in the 1.3 μm wavelength band.

We present 6.1 W of output power from a flip-chip semiconductor disk laser (SDL) emitting in the 1.3 μm wavelength region. This is the first demonstration of a flip-chip SDL in this wavelength range with output powers that are comparable to those obtained with intracavity diamond heat spreaders. The flip-chip configuration circumvents the optical distortions and losses that the intracavity diamond heat spreaders can introduce into the laser cavity. This is essential for several key applications of SDLs.

Self-mode-locked quantum-dot vertical-external-cavity surface-emitting laser.

We present the first self-mode-locked optically pumped quantum-dot semiconductor disk laser. Our mode-locked device emits sub-picosecond pulses at a wavelength of 1040nm and features a record peak power of 460W at a repetition rate of 1.5GHz. In this work, we also investigate the temperature dependence of the pulse duration as well as the time-bandwidth product for stable mode locking.

Compression of the self-Q-switching in semiconductor disk lasers with single-layer graphene saturable absorbers

We demonstrate the first use of single layer graphene for compressing self-Q-switching pulses in semiconductor disk lasers. The gain region of the semiconductor disk laser used InGaAs quantum wells with a central wavelength of 1030 nm. Due to self saturable absorption of the quantum wells, the disk laser emitted at the self-Q-switching state with a pulse width of 13 μs. By introducing the single layer graphene as a saturable absorber into the V-shaped laser cavity, the pulse width of the self-pulse was compressed to 2 μs with a lower pump power of 300 mW. As the pump power was increased, multiple pulses with the pulse width of 1.8 μs appeared. The compression factor was about 7.2.

Gigahertz self-referenceable frequency comb from a semiconductor disk laser.

We present a 1.75-GHz self-referenceable frequency comb from a vertical external-cavity surface-emitting laser (VECSEL) passively modelocked with a semiconductor saturable absorber mirror (SESAM). The VECSEL delivers 231-fs pulses with an average power of 100 mW and is optimized for stable and reliable operation. The optical spectrum was centered around 1038 nm and nearly transform-limited with a full width half maximum (FWHM) bandwidth of 5.5 nm. The pulses were first amplified to an average power of 5.5 W using a backward-pumped Yb-doped double-clad large mode area (LMA) fiber and then compressed to 85 fs with 2.2 W of average power with a passive LMA fiber and transmission gratings. Subsequently, we launched the pulses into a highly nonlinear photonic crystal fiber (PCF) and generated a coherent octave-spanning supercontinuum (SC). We then detected the carrier-envelope offset (CEO) frequency (f(CEO)) beat note using a standard f-to-2f-interferometer. The f(CEO) exhibits a signal-to-noise ratio of 17 dB in a 100-kHz resolution bandwidth and a FWHM of ≈10 MHz. To our knowledge, this is the first report on the detection of the f(CEO) from a semiconductor laser, opening the door to fully stabilized compact frequency combs based on modelocked semiconductor disk lasers.

A 23-watt single-frequency vertical-external-cavity surface-emitting laser.

We report on a single-frequency semiconductor disk laser which generates 23.6 W output power in continuous wave operation, at a wavelength of 1013 nm. The high output power is a result of optimizing the chip design, thermal management and the cavity configuration. By applying passive stabilization techniques, the free-running linewidth is measured to be 407 kHz for a sampling time of 1 ms, while undercutting 100 kHz in the microsecond domain.

A 1.33 µm picosecond pulse generator based on semiconductor disk mode-locked laser and bismuth fiber amplifier.

We demonstrate that a combination of ultrafast wafer bonded semiconductor disk laser and a bismuth-doped fiber amplifier provides an attractive design for high power 1.33 µm tandem hybrid systems. Over 0.5 W of average output power was achieved at a repetition rate of 827 MHz that corresponds to a pulse energy of 0.62 nJ.

Graphene saturable absorber for high power semiconductor disk laser mode-locking

Here, we report on the development of an antiresonant graphene-based one-dimensional structure which allows the control of linear and nonlinear device performance through optical confinement. A record average output in excess of 10 W is achieved by integrating this antiresonant graphene saturable absorber mirror into a vertical-external-cavity-surface-emitting-laser at 1030 nm, which leads to strong evidence of mode-locking, generating pulses with energies up to 2.8 nJ and a pulsewidth of 353 fs.

Interferometric Characterization of a Semiconductor Disk Laser driven Terahertz Source

Michelson interferometry is used to investigate the pump-power dependent emission bandwidth of a THz emitter based on intra-cavity difference frequency generation in a two-color VECSEL. A multi-mode CW THz signal is found to result from the two simultaneously lasing groups of longitudinal VECSEL modes. Power-dependent experiments reveal a clear correlation between the THz signal bandwidth and the numbers of optical modes involved.

High power semiconductor disk laser with a semiconductor-dielectric-metal compound mirror

We present optically pumped semiconductor disk lasers with a thin dielectric layer placed between the semiconductor distributed Bragg reflector and the metallization interface. The approach is shown to enhance the reflectivity of the semiconductor mirror while introducing a negligible penalty to the thermal resistance of the device. The design has potential for improving the performance of semiconductor disk lasers by avoiding highly pump-absorbing metal layers and allowing thinner mirror structures. The advantages are expected to be especially prominent for material systems that employ thick thermally insulating semiconductor mirrors.

Pulse repetition rate scaling from 5 to 100 GHz with a high-power semiconductor disk laser

The high-power semiconductor laser studied here is a modelocked integrated external-cavity surface emitting laser (MIXSEL), which combines the gain of vertical-external-cavity surface-emitting lasers (VECSELs) with the saturable absorber of a semiconductor saturable absorber mirror (SESAM) in a single semiconductor layer stack. The MIXSEL concept allows for stable and self-starting fundamental passive modelocking in a simple straight cavity and the average power scaling is based on the semiconductor disk laser concept. Previously record-high average output power from an optically pumped MIXSEL was demonstrated, however the long pulse duration of 17 ps prevented higher pulse repetition rates and many interesting applications such as supercontinuum generation and broadband frequency comb generation. With a novel MIXSEL structure, the first femtosecond operation was then demonstrated just recently. Here we show that such a MIXSEL can also support pulse repetition rate scaling from ≈5 GHz to >100 GHz with excellent beam quality and high average output power, by mechanically changing the cavity length of the linear straight cavity and the output coupler. Up to a pulse repetition rate of 15 GHz we obtained average output power >1 W and pulse durations <4 ps. Furthermore we have been able to demonstrate the highest pulse repetition rate from any fundamentally modelocked semiconductor disk laser with 101.2 GHz at an average output power of 127 mW and a pulse duration of 570 fs.

Harmonic self‐mode‐locking of optically pumped semiconductor disc laser

A saturable-absorber-free vertical-external-cavity surface-emitting laser is presented which is harmonically modelocked. Modelocking is initiated via fine-tuning of an aperture which is placed near one of the cavity's end mirrors. Fundamental modelocking is observed along with the second and third harmonic operations for increased optical pump powers. The system features pulse durations penetrating the femtosecond regime at a wavelength of 1014 nm.