AbstractThe self‐potential (SP) method is expected to play an important role in the exploration of seafloor massive sulfide (SMS) resources. Since the redox potential changes with depth below the seafloor, SMS deposits are the source of an electrical (source) current density, generating in turn a recordable electrical field. This electrical field can be remotely measured at and above the seafloor. By integrating this electrical field, we obtained a so‐called SP profile or map. The electrical conductivity distribution of SMS deposits is an important ingredient in the inversion of these SP data in order to distinguish between causative primary sources (i.e., associated with the SMS deposits themselves) and secondary current sources associated with conductivity contrasts below the seafloor. Such ingredient is therefore necessary to properly localize SMS deposits and eliminating ghosts associated with high conductivity contrasts. The conductivity structure of the seafloor is however unknown in most SP surveys. This study presents the first joint interpretation of transient electromagnetic and SP surveys. The field data were acquired at the Trans‐Atlantic Geotraverse (TAG) hydrothermal mound. The conductivity structure of TAG mound was obtained by inverting transient electromagnetic data. This electrical conductivity distribution is then used to invert the SP data. The obtained (primary) source current distribution delineates the geometry of the SMS deposits. The deposits are located in the center of the mound as well as at its edges, in a way that is consistent with water column data. Combining the two geophysical methods improves our ability to better decipher the fine geometry of SMS deposits below the seafloor.