The possibility to directly extrude semi-finished products using a solid-state-recycling process is a promising alternative to the remelting process, which is highly energy-intensive. Therefore, aluminium chips, normally considered as scrap, are used as the basis for the recycling. The recycling process consists of a cold compaction process, a field-assisted sintering (FAST) process to consolidate the chips, and finally a forward rod extrusion process. Compared to approaches which break the oxide layers by applying high shear stresses and deformations, necessary for an adequate welding of the chips, quasistatic and cyclic properties and capabilities are significantly increased. The defect structure of specimens, which was determined by means of computed tomography and which significantly influences the lifetime, could be correlated well with pre-test electrical resistance measurements. Finally, these findings were used to establish a lifetime calculation model based on unique electrical resistance measurements prior to mechanical testing.