Quantum Noise Limited Sensitivity Research Articles

Quantum enhanced kHz gravitational wave detector with internal squeezing

We propose adding a nonlinear element to a long signal recycling cavity to enhance the high-frequency sensitivity (900 Hz–5 kHz) of a kilometer-scale interferometric gravitational wave detector. Using numbers for absorption and scattering losses in the detector consistent with advanced LIGO+, we demonstrate a factor of 3.5 improvement in quantum noise limited strain sensitivity in the kHz regime. Such a configuration is robust to internal losses and reduces the requirement on the amount of circulating power in the detector to achieve sensitivity comparable to future gravitational wave detectors. This proposed configuration is compatible with the existing gravitational wave detector vacuum infrastructure and could enable exploration of exotic science, such as observing the merger phase of binary neutron stars, which in turn may provide constraints on the neutron star equation of state.

Overcoming standard quantum limit using a momentum measuring interferometer.

We show that back-action noise in the momentum measurement of a damped forced oscillator can be suppressed because of damping. Using this principle, we propose a back-action suppressed interferometer, in which the signal is a function of momentum of atoms in a harmonic trap. We show that the quantum noise limited sensitivity of this interferometer can overcome the standard quantum limit of force sensing, even at frequencies much smaller than the eigen frequency of the harmonic trap.

Effects of static and dynamic higher-order optical modes in balanced homodyne readout for future gravitational waves detectors

With the recent discovery of Gravitational waves, marking the start of the new field of GW astronomy, the push for building more sensitive laser-interferometric gravitational wave detectors (GWD) has never been stronger. Balanced homodyne detection (BHD) allows for a quantum noise limited readout of arbitrary light field quadratures, and has therefore been suggested as a vital building block for upgrades to Advanced LIGO and third generation observatories. In terms of the practical implementation of BHD, we develop a full framework for analyzing the static optical high order modes (HOMs) occurring in the BHD paths related to the misalignment or mode matching at the input and output ports of the laser interferometer. We find the effects of HOMs on the quantum noise limited sensitivity is independent of the actual interferometer configuration, e.g. Michelson and Sagnac interferometers are effected in the same way. We show that output misalignment only effects the high frequency part of the quantum noise limited sensitivity. However, at low frequencies, HOMs reduce the interferometer response and the radiation pressure noise by the same amount and hence the quantum noise limited sensitivity is not negatively effected. We show that the input misalignment to the interferometer produces the same effect as output misalignment and additionally decreases the power inside the interferometer. We also analyze dynamic HOM effects, such as beam jitter created by the suspended mirrors of the BHD. Our analyses can be directly applied to any BHD implementation in a future GWD. Moreover, we apply our analytical techniques to the example of the speed meter proof of concept experiment under construction in Glasgow. We find that for our experimental parameters, the performance of our seismic isolation system in the BHD paths is compatible with the design sensitivity of the experiment.

Potential of a superconducting photon counter for heterodyne detection at the telecommunication wavelength.

Here, we report on the successful operation of a NbN thin film superconducting nanowire single-photon detector (SNSPD) in a coherent mode (as a mixer) at the telecommunication wavelength of 1550 nm. Providing the local oscillator power of the order of a few picowatts, we were practically able to reach the quantum noise limited sensitivity. The intermediate frequency gain bandwidth (also referred to as response or conversion bandwidth) was limited by the spectral band of a single-photon response pulse of the detector, which is proportional to the detector size. We observed a gain bandwidth of 65 MHz and 140 MHz for 7 × 7 µm2 and 3 × 3 µm2 devices, respectively. A tiny amount of the required local oscillator power and wide gain and noise bandwidths, along with unnecessary low noise amplification, make this technology prominent for various applications, with the possibility for future development of a photon counting heterodyne-born large-scale array.

Candidates for a possible third-generation gravitational wave detector: comparison of ring-Sagnac and sloshing-Sagnac speedmeter interferometers

Speedmeters are known to be quantum non-demolition devices and, by potentially providing sensitivity beyond the standard quantum limit, become interesting for third generation gravitational wave detectors. Here we introduce a new configuration, the sloshing-Sagnac interferometer, and compare it to the more established ring-Sagnac interferometer. The sloshing-Sagnac interferometer is designed to provide improved quantum noise limited sensitivity and lower coating thermal noise than standard position meter interferometers employed in current gravitational wave detectors. We compare the quantum noise limited sensitivity of the ring-Sagnac and the sloshing-Sagnac interferometers, in the frequency range, from 5 Hz to 100 Hz, where they provide the greatest potential benefit. We evaluate the improvement in terms of the unweighted noise reduction below the standard quantum limit, and by finding the range up to which binary black hole inspirals may be observed. The sloshing-Sagnac was found to give approximately similar or better sensitivity than the ring-Sagnac in all cases. We also show that by eliminating the requirement for maximally-reflecting cavity end mirrors with correspondingly-thick multi-layer coatings, coating noise can be reduced by a factor of approximately 2.2 compared to conventional interferometers.

Quantum noise limits in white-light-cavity-enhanced gravitational wave detectors

Previously, we had proposed a gravitational wave detector that incorporates the white-light-cavity (WLC) effect using a compound cavity for signal recycling (CC-SR). Here, we first use an idealized model for the negative dispersion medium (NDM) and use the so-called Caves model for a phase-insensitive linear amplifier to account for the quantum noise (QN) contributed by the NDM, in order to determine the upper bound of the enhancement in the sensitivity-bandwidth product. We calculate the quantum noise limited sensitivity curves for the CC-SR design, and find that the broadening of sensitivity predicted by the classical analysis is also present in these curves, but is somewhat reduced. Furthermore, we find that the curves always stay above the standard quantum limit. To circumvent this limitation, we modify the dispersion to compensate the non-linear phase variation produced by the optomechanical resonance effects. We find that the upper bound of the factor by which the sensitivity-bandwidth product is increased, compared to the highest-sensitivity result predicted by Bunanno and Chen [Phys. Rev. D 64, 042006 (2001)], is ~14. We also present a simpler scheme (WLC-SR) where a dispersion medium is inserted into the SR cavity. For this scheme, we found the upper bound of the enhancement factor to be ~18. We then consider an explicit system for realizing the NDM, which makes use of five energy levels in M-configuration to produce gain, accompanied by electromagnetically induced transparency (the GEIT system). For this explicit system, we employ the rigorous approach based on Master Equation to compute the QN contributed by the NDM, thus enabling us to determine the enhancement in the sensitivity-bandwidth product definitively rather than the upper bound thereof. Specifically, we identify a set of parameters for which the sensitivity-bandwidth product is enhanced by a factor of 17.66.

Quantum noise of non-ideal Sagnac speed meter interferometer with asymmetries

The speed meter concept has been identified as a technique that can potentially provide laser-interferometric measurements at a sensitivity level which surpasses the standard quantum limit (SQL) over a broad frequency range. As with other sub-SQL measurement techniques, losses play a central role in speed meter interferometers and they ultimately determine the quantum noise limited sensitivity that can be achieved. So far in the literature, the quantum noise limited sensitivity has only been derived for lossless or lossy cases using certain approximations (for instance that the arm cavity round trip loss is small compared to the arm cavity mirror transmission). In this article we present a generalized, analytical treatment of losses in speed meters that allows accurate calculation of the quantum noise limited sensitivity of Sagnac speed meters with arm cavities. In addition, our analysis allows us to take into account potential imperfections in the interferometer such as an asymmetric beam splitter or differences of the reflectivities of the two arm cavity input mirrors. Finally, we use the examples of the proof-of-concept Sagnac speed meter currently under construction in Glasgow and a potential implementation of a Sagnac speed meter in the Einstein Telescope to illustrate how our findings affect Sagnac speed meters with metre- and kilometre-long baselines.

Fundamental quantum interferometry bound for the squeezed-light-enhanced gravitational wave detector GEO 600

The fundamental quantum interferometry bound limits the sensitivity of an interferometer for a given total rate of photons and for a given decoherence rate inside the measurement device.We theoretically show that the recently reported quantum-noise limited sensitivity of the squeezed-light-enhanced gravitational-wave detector GEO600 is exceedingly close to this bound, given the present amount of optical loss. Furthermore, our result proves that the employed combination of a bright coherent state and a squeezed vacuum state is generally the optimum practical approach for phase estimation with high precision on absolute scales. Based on our analysis we conclude that neither the application of Fock states nor N00N states or any other sophisticated nonclassical quantum states would have yielded an appreciably higher quantum-noise limited sensitivity.

Heterodyne interferometer scheme using a double pass in an acousto-optic modulator

We introduce a heterodyne interferometer scheme utilizing the double-pass arrangement of the deflected beams of an acousto-optic modulator. To prove our new idea, the interferometer has been applied for measuring small amplitude vibrations. The output intermediate frequency signal from the interferometer is processed by using an I/Q demodulator. In theory, it can provide the quantum noise limited sensitivity, whereas, in our present Letter, the sensitivity of the phase measurement is limited by the resolution of the 16 bit A/D converter used for processing the I/Q signals. Details of our interferometer scheme are discussed.

Sensitivity below the standard quantum limit in gravitational wave detectors with Michelson-Fabry-Perot readout

We calculate the quantum noise limited displacement sensitivity of a Michelson-Fabry-Perot (MFP) interferometer with detuned cavities, followed by phase-sensitive homodyne detection. We show that the standard quantum limit can be surpassed even with resonant cavities and without any signal-recycling mirror nor additional cavities. Indeed, thanks to the homodyne detection, the output field quadrature can be chosen in such a way to cancel the effect of input amplitude fluctuations, i.e., eliminating the force noise. With detuned cavities, the modified opto-mechanical susceptivity allows to reach unlimited sensitivity for large enough (yet finite) optical power. Our expressions include mirror losses and cavity delay effect, for a realistic comparison with experiments. Our study is particularly devoted to gravitational wave detectors and we consider both an interferometer with free-falling mirrors, and a MFP interferometer as readout for a massive detector. In the latter case, the sensitivity curve of the recently conceived ''DUAL'' detector, based on two acoustic modes, is obtained.