To evaluate exvivo the effect of several simulated pulpal blood flow rates on the change in pulp chamber temperature during direct fabrication of a provisional restoration using a polymethylmethacrylate (PMMA) resin. Fifteen noncarious human premolars were prepared for complete coverage restorations. A curved needle connected to a peristaltic pump simulated the pulp blood flow. Two K-type thermocouples connected to a digital thermometer were placed in the pulp chamber, and the assembly was placed in an incubator at 37°C. Three provisional crowns were made for each specimen using no water flow (group 1), a 1-mLmin-1 flow rate (group 2) and a 0.5-mL/min-1 flow rate (group 3). The pulp chamber temperature was recorded continuously during polymerization until the temperature increase peaked and started to decrease and reached the baseline temperature (37°C). The temperature increase was measured for the three water flow conditions. Data were analysed statistically using descriptive statistics, repeated measures one-way analysis of variance (anova) with Greenhouse-Geisser correction and Bonferroni tests. The level of significance was set at P<0.05. All of the groups were associated with an increased pulp chamber temperature. Groups with flow rates at 1 and 0.5mLmin-1 had a significantly lower temperature rise when compared to the group without water flow (P<0.001). Direct fabrication of provisional restorations can cause a critical increase in pulp chamber temperature. However, in the presence of simulated pulpal blood flow rates of 1 or 0.5mLmin-1 , the increase in pulp chamber temperature did not exceed the critical threshold (5.6°C).