Pre-synchronization Control Research Articles

Research on the Operation Control Strategy of a Low-Voltage Direct Current Microgrid Based on a Disturbance Observer and Neural Network Adaptive Control Algorithm

Low-voltage direct current (DC) microgrid based on distributed generation (DG), the problems of load mutation affecting the DC bus under island mode, and the security problems that may arise when the DC microgrid is switched from island mode to grid-connected mode are considered. Firstly, a DC bus control algorithm based on disturbance observer (DOB) was proposed to suppress the impact of system load mutation on DC bus in island mode. Then, in a grid-connected mode, a pre-synchronization control algorithm based on a neural network adaptive control was proposed, and the droop controller was improved to ensure better control accuracy. Through this pre-synchronization control, the microgrid inverters output voltage could quickly track the power grid’s voltage and achieve an accurate grid-connected operation. The effectiveness of the algorithms was verified by simulation.

Research on pre-synchronization control strategy of the micro-grid with multi-VSG

Seamless switching is an important guarantee for the inverter to work continuously without stopping when grid-connected power generation system is the transient process from grid-connected to isolated island and from isolated island reclosing. Based on the principle of pre-synchronous operation of traditional synchronous generators, this paper analyzes the principle of pre-synchronous process and its effect on the steady-state of micro grid with multiple virtual synchronous generators. At the same time, the paper analyzes the transient influence of the closed pre-synchronous switch on the power distribution of the micro grid under different phase modes. This paper proposes a pre-synchronous control strategy based on phase recognition. MATLAB/Simulink simulation software is used to verify the correctness and validity of the proposed method.