Verticillium wilt, caused by Verticillium dahliae Kleb., is a primary component of the early dying complex of potato (Solanum tuberosum L.) in the United States. Although genetic resistance to V. dahliae exists and has been incorporated into several potato cultivars, the commercial potato industry is still dominated by cultivars susceptible to the pathogen. As a result, soil fumigation with metam sodium remains an important means by which Verticillium wilt is controlled, despite its expense and potentially negative environmental impact. Recent restrictions on metam sodium use by the Environmental Protection Agency directed at reducing exposure to vapor emissions have increased the need to improve shank injection of the soil fumigant. In studies reported here, the application of metam sodium reduced the severity of Verticillium wilt, however, soil temperature at the time of injection, metam sodium injection depth, and application rate had little overall effect. In 2011, temperature at the time of metam sodium injection did not result in significant differences in any parameter evaluated. However, in 2012, soil populations of V. dahliae, wilt severity and host colonization were significantly reduced when metam sodium was applied at 4 °C compared to 13 or 15 °C. No significant differences were observed between a single or two metam sodium injection depths in any parameter evaluated across the 2 years the study was conducted. While all rates of metam sodium significantly reduced soil populations of V. dahliae compared to the non-treated control, significant differences across rates were rarely observed. Improved control of Verticillium wilt and increased yield can be achieved as a result of these studies. The effective control of Verticillium wilt can be obtained by using metam sodium at a comparatively low rate of 373 l/ha, particularly when applied at a relatively cold soil temperature of 4 °C using a single injection depth of 25 cm. The potential impact of these application modifications of metam sodium in reducing emissions and non-target exposure is discussed.