3D printing via material extrusion is capable of using polymeric materials for a large range of applications. They are generally used, however, for prototyping as opposed to creating functional parts due to their lower mechanical properties in comparison to other materials, such as metals or epoxies, and processing methods, such as compression molding or injection molding. Carbon fiber, glass fiber, and kevlar have been used as reinforcement materials with very positive results in terms of creating functional parts. However, little focus has been placed on metallic wire reinforcement. In this investigation, a novel strategy to manufacture continuous metallic wire-reinforced polymer–matrix composites with increased mechanical properties by material extrusion is presented. A customized multimaterial 3D printer was built and used to fabricate coupons of unidirectionally reinforced Al wire/PLA matrix composites with either 15% or 25% wire volume fraction. The microstructure of the composites was analyzed to understand the formation of porosity during processing. These results also showed the potential of the manufacturing technique to precisely control the wire location and orientation. Incorporation of a volume fraction 25% of Al wires led to a 600% increase in elastic modulus and a 63% increase in tensile strength compared to pure PLA. These results indicate an efficient load transfer between the polymer matrix and the incorporated wires, despite exhibiting a relatively low interface strength. Overall, the novel strategy opens the possibility to manufacture high volume fraction composite laminates of thermoplastic polymers reinforced with metallic wires by material extrusion.
Read full abstract