Plasma-polymerized Ethylenediamine Film Research Articles

Aging effects of plasma polymerized ethylenediamine (PPEDA) thin films on cell-adhesive implant coatings

Thin plasma polymer films from ethylenediamine were deposited on planar substrates placed on the powered electrode of a low pressure capacitively coupled 13.56MHz discharge. The chemical composition of the plasma polymer films was analyzed by Fourier Transform Infrared Reflection Absorption Spectroscopy (FT-IRRAS) as well as by X-ray photoelectron spectroscopy (XPS) after derivatization of the primary amino groups. The PPEDA films undergo an alteration during the storage in ambient air, particularly, due to reactions with oxygen. The molecular changes in PPEDA films were studied over a long-time period of 360days. Simultaneously, the adhesion of human osteoblast-like cells MG-63 (ATCC) was investigated on PPEDA coated corundum blasted titanium alloy (Ti-6Al-4V), which is applied as implant material in orthopedic surgery. The cell adhesion was determined by flow cytometry and the cell shape was analyzed by scanning electron microscopy. Compared to uncoated reference samples a significantly enhanced cell adhesion and proliferation were measured for PPEDA coated samples, which have been maintained after long-time storage in ambient air and additional sterilization by γ−irradiation.

Optimization of Plasma Polymerized Ethylenediamine Film Chemistry on Quartz Particles

Ethylenediamine plasma polymerization has been investigated to modify the surface of quartz particles to optimize the nitrogen concentration of coatings produced via a rotating barrel plasma reactor. Plasma polymerized ethylenediamine (ppED) films were deposited at varying powers, flow rates, and polymerization times. X-ray photoelectron spectroscopy indicated that plasma power appeared to have little effect on ppED chemistry while increasing the ethylenediamine flow rate and polymerization time increased the nitrogen concentration due to reduced fragmentation and increased film thickness respectively. Time of flight secondary-ion mass spectrometry demonstrated uniform distribution of nitrogen species across the particle surface. Ethylenediamine plasma polymerization using a rotating plasma reactor has shown to be a successful method for producing nitrogen rich particle coatings.

Culturing of Rat Intestinal Epithelial Cells-18 on Plasma Polymerized Ethylenediamine Films Deposited by Plasma Enhanced Chemical Vapor Deposition

Many researchers studied cell culturing on surfaces with chemical functional groups. Previously, we reported surface properties of plasma polymerized ethylenediamine (PPEDA) films deposited by plasma enhanced chemical vapor deposition with various plasma conditions. Surface properties of PPEDA films can be controlled by plasma power during deposition. In this work, to analyze correlation of cell adherence/proliferation with surface property, we cultured rat intestinal epithelial cells-18 on the PPEDA films deposited with various plasma powers. It was shown that as plasma power was decreased, density of cells cultured on the PPEDA film surface was increased. Our findings indicate that plasma power changed the amine density of the PPEDA film surface, resulting in density change of cells cultured on the PPEDA film surface.

Simultaneous detection of five indices of hepatitis B based on an integrated automatic microfluidic device

Immunophenotyping evaluation is of particular importance for the clinical diagnosis, therapy, and prognosis of viral hepatitis. In this study, an integrated micro flow device has been developed to detect the differentiated antigens/antibodies for immunophenotyping of viral hepatitis. The sensors were fabricated with plasma-polymerized ethylenediamine film (PPF) and nanometer-sized gold particles (nanogold) on which the different hepatitis B antigens/antibodies (markers) were subsequently immobilized. Monitoring the changes in the potential signals before and after the antigen-antibody interaction provides the basis for an immunoassay that is simple, rapid, and cost-effective. It permits the detection of hepatitis B in the dynamic concentration range of 2 orders of magnitude (10(-6) g x L(-1) - 10(-4) g x L(-1)). Up to 7 successive assay cycles with retentive sensitivity were achieved for the sensors regenerated by 8 M urea. Moreover, the microfluidic device was applied to evaluate a number of practical specimens with analytical results in acceptable agreement with those clinically classified. The newly proposed multiparameter analysis technique provides a feasible alternative tool for the diagnosis and monitoring of hepatitis B.

Quantitative analysis of surface amine groups on plasma-polymerized ethylenediamine films using UV–visible spectroscopy compared to chemical derivatization with FT-IR spectroscopy, XPS and TOF-SIMS

A quantitative analysis of the surface density of amine groups on a plasma-polymerized ethylenediamine thin film deposited on a platinum surface using inductively coupled plasma chemical vapor deposition method is described. UV–visible spectroscopy together with a chemical derivatization technique using Fourier transform infrared (FT-IR) spectroscopy was used to obtain the quantitative information. Chemical tags of pentafluorobenzaldehyde were hybridized with the surface amine groups and were easily detected due to the characteristic absorption bands of C–F stretching, aromatic ring and C N stretching vibrations in the reflection–absorption FT-IR spectra. The surface amine density was reproducibly controlled as a function of deposition plasma power and quantified using UV–visible spectroscopy. A good linear correlation was observed between the FT-IR intensities of the characteristic absorption bands and the surface amine densities, suggesting the possibility of using this chemical derivatization technique to quantify the surface densities of specific functional groups on an organic surface. Chemical derivatization was also used with X-ray photoelectron spectroscopy on the same samples, and the results were compared with those obtained from FT-IR and time-of-flight secondary ion mass spectrometry. Although each analysis technique has different probing depths from the surface, the three different data sets obtained from the chemical tags correlated well with each other since each analysis technique measured the chemical tags on the sample surface.

Chemical derivatization technique in ToF-SIMS for quantification analysis of surface amine groups

A chemical derivatization technique in ToF-SIMS along with principal component analysis (PCA) were used to perform a quantitative study of the surface amine density of the plasma-polymerized ethylenediamine (PPEDA) thin film. We used the scores on principal component (PC) 1 from a PCA of ToF-SIMS data for the PPEDA films and their chemical-derivatized surfaces for comparison with the surface amine densities. These surface amine densities were independently determined by UV–visible spectroscopy. Our work found a good linear relationship between the surface amine densities and the scores on PC 1 from a PCA of the ToF-SIMS data for the chemical-derivatized PPEDA surfaces, but not for the PPEDA thin films themselves. In addition to quantification, our PCA results provided insights into the surface chemical composition of each surface.

Formation of amine groups by plasma enhanced chemical vapor deposition and its application to DNA array technology

A plasma enhanced chemical vapor deposition (PECVD) method using plasma polymerized ethylenediamine (PPEDA) was employed to coat glass slides with amine functional groups. Fluorescein isothiocyanate (FITC) labeling indicated that the density of amine functional groups on these coated slides was affected by PECVD conditions, particularly deposition time. The PPEDA-coated slides were used for the development of DNA arrays. 5′-Amino-modified oligodeoxyribonucleotides (ODNs) and cDNA strands were immobilized onto PPEDA-coated slides and used for hybridization to labeled target strands. In addition, patterning of amine groups, which is a very useful technique for preparing high-density DNA arrays, was achieved by selectively depositing PPEDA films on specific areas of a glass surface. These results demonstrate that the formation of amine groups on glass slides by PECVD is an excellent tool for DNA array technology.

Quantitative Chemical Derivatization Technique in Time-of-Flight Secondary Ion Mass Spectrometry for Surface Amine Groups on Plasma-Polymerized Ethylenediamine Film

A chemical derivatization technique in time-of-flight secondary ion mass spectrometry (TOF-SIMS) has been developed to quantify the surface density of amine groups of plasma-polymerized ethylenediamine thin film deposited on a glass surface by inductively coupled plasma chemical vapor deposition. Chemical tags of 4-nitrobenzaldehyde or pentafluorobenzaldehyde were hybridized with the surface amine groups and were detected in TOF-SIMS spectra as characteristic molecular secondary ions. The surface amine density was controlled in a reproducible manner as a function of deposition plasma power and was also quantified using UV-visible spectroscopy. A good linear correlation was observed between the results of TOF-SIMS and UV-visible measurements as a function of plasma power. This shows that the chemical derivatization technique in TOF-SIMS analysis would be useful in quantifying the surface density of specific functional groups that exist on the organic surface.

A potentiometric acetylcholinesterase biosensor based on plasma-polymerized film

A potentiometric acetylcholinesterase biosensor based on pH-sensitive PVC membrane with plasma-polymerized ethylenediamine film has been proposed. Glow discharge plasma technique was utilized to deposit a film containing amino groups on the surface of pH-sensitive PVC membrane. Such an approach makes it possible to fabricate a very simple self-mounted acetylcholinesterase membrane directly attached to PVC pH-sensing electrode surface. The deposition conditions were optimized and the optimum plasma polymerization parameters were as follows: applied power, 75 W; pressure, 130 Pa; plasma exposure time, 60 min and flow rates, 10 ml min −1. Two neutral carriers, DOODA and DAMAB were compared as the pH-carrier, and the biosensor based on DAMAB showed better response characteristics. The effect of pH of the medium was also examined. The potential responses of biosensor increase with the acetylcholine chloride concentration over the concentration range of 10 −6 to 10 −1 mol dm −3 and the detection limit is 0.002 mmol dm −3 in pH 8.0 PB buffer solution. The biosensor was employed more than 200 times in 20 days while the maximum response span of biosensor retained 90%.

A plasma-polymerized film for capacitance immunosensing

A capacitance immunosensor based on a plasma-polymerized ethylenediamine film (PPEF) has been developed. The resulting PPEF is studied with scanning electrode micrograph (SEM), IR reflection spectrum and cyclic voltammetry. SEM and IR reflection spectrum showed that the plasma-polymerized film (PPF) formed on the gold electrode surface is quite homogeneous, flat, nonporous and contains plenty of free-reacted NH 2. Moreover, cyclic voltammetry showed that the hexacyanoferrate redox reactions were blocked well by the formed PPF, that is to say, the formed PPF has excellent insulating characteristics. To investigate its applicability for capacitive immunosensing, goat-anti-human IgG antibody (IgGAb) was coupled to the PPF-coated gold electrode surface via glutaraldehyde (GA) to form an immunoglobulin G (IgG) probe. Alternating current (ac) impedance and capacitance measurement were used in the immunoassay. The experiment results show that the PPEF is applicable to form insulating layer of capacitive immunosensors.

Protein immobilization on plasma-polymerized ethylenediamine-coated glass slides

For protein chip construction, protein immobilization on the surface of the glass slide is essential. It was previously reported that glass slides are embedded with chemicals that contain primary amines and aldehydes for protein immobilization. We fabricated a plasma-polymerized ethylenediamine (PPEDA)-coated slide that exposed primary amines. For the plasma polymer deposition on the glass slide, the inductively coupled plasma (ICP) power was found to be a critical factor in sustaining a high density of amine on the surface of the PPEDA films. We prepared PPEDA-coated slides at three different ICP powers (3, 30, or 70 W). In the slide that was prepared at a low ICP power (3 W), we detected a high density of primary amine. Therefore, the fluorescein isothiocyanate-conjugated immunoglobulin G (IgG) was highly immobilized to the PPEDA-coated slide that was prepared at the low ICP power. For protein immobilization, 1-ethyl-3-[3-dimethylaminopropyl]carbodiimide hydrochloride (EDC) was used as a cross-linker. The immobilization of the protein to the PPEDA-coated slide was carried out by consecutive incubations with 1 mg/ml EDC for 5 min and 0.1 mg/ml IgG for 1 h. This efficiently produced the functionally active protein-immobilized slide. Therefore, this work shows that the plasma technique can be applied to produce a high-quality glass surface for the immobilization of proteins and other materials.

Detection of the red tide-causing planktonAlexandrium affineby a piezoelectric immunosensor using a novel method of immobilizing antibodies

In this paper, the determination of Alexandrium affine in sea water was performed using piezoelectric immunosensors. In addition, we report a novel method of immobilizing antibodies on the quartz crystal immunosensors using plasma-polymerized ethylenediamine film. The films formed on the quartz crystals are extremely thin, homogeneous and incorporate amino groups. Sensors produced using this method show higher sensitivity than sensors made using conventional immobilization methods for example polyethylenimine or γ-aminopropyltrimethoxysilane.