Surface hardening on local bolt (C = 0.071%) with Radio Frequency (RF) - plasma nitrocarburizing apparatus has been carried out. Some local bolt component was cleaned with distilled water. The type of material of local bolt component was low carbon steel, carbon concentration 0.071%. After that the local bolt component was cleaned with acetone. The natural oxide layer on the surface of the local bolt material was etched with HF for 1 until 3 minutes. The local bolt component was cleaned again with distillation water. Then the local bolt component was sprayed with nitrogen gas. After that the local bolt component was hardened on the material surface with RF plasma nitrocarburizing at a temperature of 400 °C, for holding time 7 hours. Sample number 1 was sample before nitrocarburization. Sample number 2 was sample after nitrocarburization at a temperature of 400 °C, for 7 hours. Then the local bolt component was cut with mower as samples for microstructure observed. The samples were mounted, polished, and etched for microstructure observation with optical microscope. The surface hardness of the samples was tested with O.M.A.G micro-hardness Vickers, MHX 10, apparatus. The expenses tracking was 300 grf, and the times tracking was 15 seconds. The results show that the hardness of sample of bolt before nitrocarburization was 154.5 Kgf/mm2, after the sample was nitrocarburized at a temperature of 400 °C for 7 hours, the maximum hardness on the surface increased up to 205.6 Kgf/mm2. Matrixes on the base material were austenite, ferrite, and perlite.