Pixel CMOS Image Sensor Research Articles

A 10000 frames/s CMOS digital pixel sensor

A 352/spl times/288 pixel CMOS image sensor chip with per-pixel single-slope ADC and dynamic memory in a standard digital 0.18-/spl mu/m CMOS process is described. The chip performs snapshot image acquisition, parallel 8-bit A/D conversion, and digital readout at continuous rate of 10000 frames/s or 1 Gpixels/s with power consumption of 50 mW. Each pixel consists of a photogate circuit, a three-stage comparator, and an 8-bit 3T dynamic memory comprising a total of 37 transistors in 9.4/spl times/9.4 /spl mu/m with a fill factor of 15%. The photogate quantum efficiency is 13.6%, and the sensor conversion gain is 13.1 /spl mu/V/e/sup -/. At 1000 frames/s, measured integral nonlinearity is 0.22% over a 1-V range, rms temporal noise with digital CDS is 0.15%, and rms FPN with digital CDS is 0.027%. When operated at low frame rates, on-chip power management circuits permit complete powerdown between each frame conversion and readout. The digitized pixel data is read out over a 64-bit (8-pixel) wide bus operating at 167 MHz, i.e., over 1.33 GB/s. The chip is suitable for general high-speed imaging applications as well as for the implementation of several still and standard video rate applications that benefit from high-speed capture, such as dynamic range enhancement, motion estimation and compensation, and image stabilization.

Technology and device scaling considerations for CMOS imagers

This paper presents an analysis of the impact of device and technology scaling on active pixel CMOS image sensors. Using the SLA roadmap as a guideline, we calculate the device characteristics that are germane to the image sensing performance of CMOS imagers, and highlight the areas where the CIMOS imager technology may need to depart from "standard" CMOS technologies. The impact of scaling on those analog circuit performance that pertain to image sensing performances are analyzed. Our analyses suggest that while "standard" CMOS technologies may provide adequate imaging performance at the 2-1 /spl mu/m generation without any process change, some modifications to the fabrication process and innovations of the pixel architecture are needed to enable CMOS to perform good quality imaging at the 0.5 /spl mu/m technology generation and beyond. Finally, the challenges to the CMOS imager research community are outlined.