1 Losey, D. D., technique for estimating axial flow compressor potential peak efficiency and related performance, M. S. Thesis, Univ. of Cincinnati (1965). 2 Rains, D. A., Tip clearance flows in axial flow compressors and pumps, California Institute of Technology, Hydrodynamics and Mechanical Engineering Lab., Rept. 5 (June 1964). 3 Carter, A. D. S., Moss, C. S., Green G. R., and Amnear, G. G., The effect of Reynolds number on the performance of a single-stage compressor, Ministry of Aviation Aeronautical Research Council, Rept. and Memo. 3184 (1960). * Sheets, H. E., The slotted blade axial flow blower, Trans. Am. Soc. Mech. Engrs. 78, 1683 (1956). 5 Sandercock, D. M., Kovach, K., and Lieblein, S., Experimental investigation of a five stage axial flow research compressor with transonic rotors in all stages. I—Compressor design, NACA RME54C26 (1954). 6 Sandercock, D. M. and Kovach, K., Experimental investigation of a five stage axial flow research compressor with transonic rotors in all stages. II—Compressor over-all performance, NACA RME54G01 (1954). 7 Sandercock, D. M. and Kovach, K., Experimental investigation of a five stage axial flow research compressor with transonic rotors in all stages. Ill—Interstage data and individual stage performance characteristics, NACA RME56G24 (1956). 8 Wiggins, J. O., A procedure for determining the off-design characteristics of multistage axial flow compressors, M. S. Thesis, Univ. of Cincinnati (1963).