An improved biomass conversion in a lab-scale fluidized bed reactor (FBR) is achieved by optimizing the air distributor orifice size and number. Two approaches for introducing air were numerically and experimentally examined. These included perforated plate and downward orifice sparger. 3 mm and 5 mm orifice diameters, and 7, 9 and 13 holes were simulated at flow velocities of 2, 4, 6, and 8 times the minimum fluidization velocity, Umf. The simulation results revealed that increasing the orifice number has a positive effect on gas holdup, particularly for the perforated plate, which showed a uniform distribution of bubbles. The sparger configuration produced larger bubbles sizes, which could lead to better recirculation of solid flux, while stagnant particle zones were observed at the lower section of both distributors.A pyrolysis unit is also inserted at the top of freeboard of the FBR. For perforated plate with 6Umf, the pyrolysis process achieved thermal and cold gas efficiencies of 82.91% and 52.03%, respectively, while combustible gases with 41.6%mol CO, 8.7%mol CH 4 and 2.17%mol HC, were obtained. For sparger pipe and 6U mf _sp, 35.33 ppm NOx and 111 ppm SO 2 were measured in flue gas from combustion process at bed region.