Modeless Dye Laser Research Articles

Ultraviolet absorption spectroscopy in optically dense fireballs using broadband second-harmonic generation of a pulsed modeless dye laser.

Broadband frequency doubling of a modeless dye laser pulse is used to enable single-shot absorption spectroscopy in the ultraviolet for optically dense, energetic-materials fireball applications. Band widths of approximately 1-3 nm are generated in the 226 and 268 nm regions using a doubling crystal. Strong focusing of the fundamental beam onto the crystal is found to be sufficient to achieve 1-5% conversion efficiency with a pulse intensity sufficient to saturate the array detector even after 75% attenuation through the fireball. The technique is demonstrated with nitric oxide (NO) absorption in a gas cell and is then used to perform the first detection and temperature fitting of aluminum monofluoride (AlF) and magnesium monofluoride (MgF) in a fireball environment.

Broadband picosecond radiation source based on noncollinear optical parametric amplifier

Amplification of broadband radiation of modeless dye laser by a noncollinear optical parametric amplifier based on a KTP crystal has been implemented upon pumping by second-harmonic pulses of a Nd : YAG laser. Pulses with a bandwidth of , a duration of and an energy of have been obtained at the centre wavelength of .

Improved temperature precision in rotational coherent anti-Stokes Raman spectroscopy with a modeless dye laser

Single-shot thermometry with dual-broadband rotational coherent anti-Stokes Raman spectroscopy that employs amplified spontaneous emission from a broadband modeless dye laser has been examined. Evaluation of single-shot spectra of air, N2, and O2 showed an improved temperature precision at room temperature compared with the precision obtained with a conventional dye laser. A comparison was also made between the use of single-mode and multimode Nd:YAG lasers as sources for narrowband radiation, and in all cases the single-mode Nd:YAG laser resulted in higher precision. The experimental results are compared with theoretical predictions.

Thermometry for turbulent flames by coherent anti-Stokes Raman spectroscopy with simultaneous referencing to the modeless excitation profile

An optimal system for temperature measurements by coherent anti-Stokes Raman spectroscopy (CARS) in turbulent flames and flows is presented. In addition to a single-mode pump laser and a modeless dye laser, an echelle spectrometer with a cross disperser is used. This system permits simultaneous measurement of the N2 CARS spectrum and the broadband dye laser profile. A procedure is developed to use software to transform this profile into the excitation profile by which the spectrum is referenced. Simultaneous shot-to-shot referencing is compared to sequential averaged referencing for data obtained in flat flames and in room air. At flame temperatures, the resultant 1.5% imprecision is limited by flame fluctuations, indicating that the system may have a single-shot imprecision below 1%. At room temperature, the 3.8% single-shot imprecision is of the same order as the best values reported for dual-broadband pure-rotational CARS. Using the unique shot-to-shot excitation profiles, simultaneous referencing eliminates systematic errors. At 2000 and 300 K, the 95% confidence intervals are estimated to be +/- 20 and +/- 10 K, respectively.

High-resolution degenerate four-wave-mixing spectroscopy of OH in a flame with a novel single-mode tunable laser

The first application of a novel single-mode tunable laser system to nonlinear spectroscopy is reported. The device uses a modeless dye laser, pumped by a single longitudinal mode (SLM) Q-switched Nd:YAG laser, as a narrow-bandwidth amplifier of the output of a SLM diode laser. The system provides pulses of 5-ns duration, 30-mJ energy and 165-MHz spectral line width tunable in the range 632–639 nm at 10-Hz repetition rate. The frequency-doubled output of the laser is used to record spectral line shapes of degenerate four wave mixing (DFWM) signals from the P1(15) line of the A2Σ–X2Π (0,0) band of OH in a methane/oxygen flame. Pressure broadening of the DFWM line shape is studied for the first time in a low-pressure flame and a pressure-broadening rate of 1.31±0.09×10-4 cm-1/Torr is derived from the data. Power-broadening effects are measured and compared with predictions of the standard perturbative model and of an analytical solution derived from a non-perturbative treatment of DFWM with arbitrary pump and probe intensities.

Cavity ring-down measurements in flames using a single-mode tunable laser system

High-resolution pulsed cavity ring-down spectroscopy (CRDS) of OH in a flame has been demonstrated using a novel single-mode tunable laser (STL). This system operates by pulse amplification of the output of a single-mode diode laser in a modeless dye laser. Ring-down curves obtained using the narrow-bandwidth STL, for both strong and weak transitions, are shown to be well fitted by single exponentials. These results are demonstrated to be in direct contrast with those obtained using a standard dye laser, for which the bandwidth is comparable to the transition linewidths and ring-down curves require multi-exponential fits. Accurate lineshape analysis is thus made possible using the STL, allowing the temperature to be derived from the measured Doppler width. The resulting measurement is in good agreement with the value derived from a Boltzmann plot of data obtained using a conventional laser in a similar flame. The advantages of using the STL system for quantitative CRDS measurements are discussed, together with a suggestion for quantitative measurements of the ASE content of narrowband lasers using CRDS.

Dual-Pump Coherent Anti-Stokes Raman Scattering Temperature and CO Concentration Measurements

Measurements of temperature and CO2 concentration using dual-pump coherent anti-Stokes Raman scattering, (CARS) are described. The measurements were performed in laboratory flames,in a room-temperature gas cell, and on an engine test stand at the U.S. Air Force Research Laboratory, Wright-Patterson Air Force Base. A modeless dye laser, a single-mode Nd:YAG laser, and an unintensified back-illuminated charge-coupled device digital camera were used for these measurements. The CARS measurements were performed on a single-laser-shot basis. The standard deviations of the temperatures and CO2 mole fractions determined from single-shot dual-pump CARS spectra in steady laminar propane/air flames were approximately 2 and 10% of the mean values of approximately 2000 K and 0.10, respectively. The precision and accuracy of single-shot temperature measurements obtained from the nitrogen part of the dual-pump CARS system were investigated in detail in near-adiabatic hydrogen/air/CO2 flames. The precision of the CARS temperature measurements was found to be comparable to the best results reported in the literature for conventional two-laser, single-pump CARS. The application of dual-pump CARS for single-shot measurements in a swirl-stabilized combustor fueled with JP-8 was also demonstrated.

High-resolution broadband N2 coherent anti-Stokes Raman spectroscopy: comparison of measurements for conventional and modeless broadband dye lasers.

We have performed high-resolution N2 coherent anti-Stokes Raman spectroscopy (CARS) measurements using a modeless dye laser (MDL) as the Stokes beam source to determine the effects of a reduction in mode noise on the accuracy and precision of the method. These results are compared with previous research that employed a conventional broadband dye laser (CBDL) as the Stokes beam source. A new spectral-fitting procedure was developed to avoid starting-point bias in the least-squares fitting results, which possibly had altered the previous measurements. Single-shot measurements of pressure were performed in a static-pressure vessel over the range of 0.1-4.0 atm to examine the pressure sensitivity of the technique. The precision of these measurements is a measure of the baseline noise level of the system, which sets the detection limit for flow-field pressure fluctuations. Centerline measurements of pressure and temperature in an underexpanded jet (Mj = 1.85) were also used to determine the performance of the technique in a compressible flow field. Our study represents the first known application, to our knowledge, of a MDL CARS system in a low-temperature, low-pressure supersonic environment. Improvements in accuracy for mean single-shot measurements and increased precision were found for pressure vessel conditions above 1.0 atm. For subatmospheric pressure vessel conditions (0.1-1.0 atm) and the underexpanded jet measurements, there was a decrease in accuracy and precision compared with the CBDL results. A comparison with the CBDL study is included, along with a discussion of the MDL system behavior.

Broadband coherent anti-Stokes Raman spectroscopy with a modeless dye laser

We develop a modeless dye laser for broadband coherent anti-Stokes Raman spectroscopy (CARS) and investigate the operational characteristics of the modeless laser. The energy efficiency of the modeless laser is 6%, and the beam divergence is 0.65 mrad. We construct a compact movable CARS system with the modeless laser and a graphite tube furnace to assess the accuracy of the CARS temperature. It is found that the difference between the averaged CARS temperature and the radiation temperature measured with an optical pyrometer is <2% at a temperature range from 1000 to 2400 K. We also measure the averaged CARS temperature drift owing to the variation of the spectral distribution of the modeless laser, which is <1.5% during 5 h of operation.

Investigation of the bandwidth dependent characteristics of stimulated Brillouin scattering using a modeless dye laser

We report on the threshold, slope efficiency and phase conjugate fidelity of stimulated Brillouin scattering excited by a modeless dye laser that has a continuously variable bandwidth. The liquid n-hexane and the gas C 2F 6 are used as Brillouin media and data is given over a bandwidth range from 130 MHz to 500 GHz. The threshold variation with bandwidth is compared with theory. A reduction in fidelity is observed when the modeless laser is replaced with one that has a longitudinal mode structure.

Noise in single-shot broadband coherent anti-Stokes Raman spectroscopy that employs a modeless dye laser

The noise in single-shot coherent anti-Stokes Raman (CARS) spectroscopy that employs a broadband modeless dye laser (MDL) is examined and the results are compared with those of a conventional dye laser. The noise of the dye-laser, the nonresonant CARS, and the resonant N(2) CARS signals are determined. The use of a MDL is shown to result in substantially reduced CARS noise when the CARS signal is generated with a single-mode pump laser, but only a marginal reduction of noise is observed with a multimode pump source The noise measurements are compared with theoretical predictions that are based on models that assume modes of random amplitudes and phases in the multimode laser sources. The combination of a MDL and a single-mode pump laser is shown to increase the precision of single-shot N(2) CARS temperature measurements.