Miniscule Volume Research Articles

A power-based abrasion law for use in landscape evolution models

AbstractSubglacial abrasion drives erosion for many glaciers, inundating forefields and proglacial marine environments with glaciogenic sediments. Theoretical treatments of this process suggest that bedrock abrasion rates scale linearly with the energy expended through rock-on-rock friction during slip, but this assumption lacks an empirical basis for general implementation. To test this approach, we simulated abrasion by sliding debris-laden ice over rock beds under subglacial conditions in a cryo-ring shear and a direct shear device. Miniscule volumes of erosion that occurred during each run were mapped with a white-light profilometer, and we measured the rock mechanical properties needed to constrain the energy expended through abrasion. We find that abraded volume per unit area increases linearly with average shear force at the bed and that abrasion rates increase linearly with basal power for plane beds. Lastly, only a small percentage (1%) of the energy partitioned to basal slip is dissipated by abrasion. These results confirm the basal-power abrasion rule is viable to implement in landscape evolution models.

An approximate analytical approach to estimate the diffusivity of toxic chemicals in polymer barrier materials from the time evolution of sessile drop profiles

Any practical technique to determine the diffusivity of chemical warfare agents in protective barrier materials should require handling only miniscule volume of the chemicals and also require data analysis methods that are not computationally burdensome. Such an approach is described here based on imaging the time evolution of ~ 1 μL sessile drop profiles on the barrier surface and using an approximate analytical approach to analyze the time-dependent drop volume and contact angle data for extracting the diffusivity. The approximate analytical approach is validated by comparison against results from computationally intensive finite element simulations available in the literature. The domain of reliable use of the sessile drop technique in terms of the relative importance of the simultaneous evaporation and absorption is assessed using measurements on three challenging toxic chemicals in air and in butyl rubber. The ability of this approach to provide reasonable diffusivity estimates even if the substrate undergoes swelling is explored by studying water sessile drops on a Nafion membrane. The results allow one to conclude that the sessile drop technique coupled to the approximate analytical approach can be reliably used for rapid screening of new barrier materials for protection against chemical warfare agents if the screening is implemented using simulants with low vapor pressures.

A review on microscale polymerase chain reaction based methods in molecular diagnosis, and future prospects for the fabrication of fully integrated portable biomedical devices.

Since the advent of microfabrication technology and soft lithography, the lab-on-a-chip concept has emerged as a state-of-the-art miniaturized tool for conducting the multiple functions associated with micro total analyses of nucleic acids, in series, in a seamless manner with a miniscule volume of sample. The enhanced surface-to-volume ratio inside a microchannel enables fast reactions owing to increased heat dissipation, allowing rapid amplification. For this reason, PCR has been one of the first applications to be miniaturized in a portable format. However, the nature of the basic working principle for microscale PCR, such as the complicated temperature controls and use of a thermal cycler, has hindered its total integration with other components into a micro total analyses systems (μTAS). This review (with 179 references) surveys the diverse forms of PCR microdevices constructed on the basis of different working principles and evaluates their performances. The first two main sections cover the state-of-the-art in chamber-type PCR microdevices and in continuous-flow PCR microdevices. Methods are then discussed that lead to microdevices with upstream sample purification and downstream detection schemes, with a particular focus on rapid on-site detection of foodborne pathogens. Next, the potential for miniaturizing and automating heaters and pumps is examined. The review concludes with sections on aspects of complete functional integration in conjunction with nanomaterial based sensing, a discussion on future prospects, and with conclusions. Graphical abstract In recent years, thermocycler-based PCR systems have been miniaturized to palm-sized, disposable polymer platforms. In addition, operational accessories such as heaters and mechanical pumps have been simplified to realize semi-automatted stand-alone portable biomedical diagnostic microdevices that are directly applicable in the field. This review summarizes the progress made and the current state of this field.

A microfluidics-based in situ chemotaxis assay to study the behaviour of aquatic microbial communities.

Microbial interactions influence the productivity and biogeochemistry of the ocean, yet they occur in miniscule volumes that cannot be sampled by traditional oceanographic techniques. To investigate the behaviours of marine microorganisms at spatially relevant scales, we engineered an in situ chemotaxis assay (ISCA) based on microfluidic technology. Here, we describe the fabrication, testing and first field results of the ISCA, demonstrating its value in accessing the microbial behaviours that shape marine ecosystems.

Microfluidic processing of synovial fluid for cytological analysis.

Cytological analysis of synovial fluid is widely used in the clinic to assess joint health and disease. However, in general practice, only the total number of white blood cells (WBCs) are available for cytologic evaluation of the joint. Moreover, sufficient volume of synovial aspirates is critical to run conventional analyses, despite limited volume of aspiration that can normally be obtained from a joint. Therefore, there is a lack of consistent and standardized synovial fluid cytological tests in the clinic. To address these shortcomings, we developed a microfluidic platform (Synovial Chip), for the first time in the literature, to achieve repeatable, cost- and time-efficient, and standardized synovial fluid cytological analysis based on specific cell surface markers. Microfluidic channels functionalized with antibodies against specific cell surface antigens are connected in series to capture WBC subpopulations, including CD4+, CD8+, and CD66b+cells, simultaneously from miniscule volumes (100μL) of synovial fluid aspirates. Cell capture specificity was evaluated by fluorescent labeling of isolated cells in microchannels and was around 90% for all three WBC subpopulations. Furthermore, we investigated the effect of synovial fluid viscosity on capture efficiency in the microfluidic channels and utilized hyaluronidase enzyme treatment to reduce viscosity and to improve cell capture efficiency (>60%) from synovial fluid samples. Synovial Chip allows efficient and standardized point-of-care isolation and analysis of WBC subpopulations in miniscule volumes of patient synovial fluid samples in the clinic.

Microdroplet-Based Potentiometric Redox Measurements on Gold Nanoporous Electrodes.

Potentiometric redox measurements were made in subnanoliter droplets of solutions using an optically transparent nanoporous gold electrode strategically mounted on the stage of an inverted microscope. Nanoporous gold was prepared via dealloying gold leaf with concentrated nitric acid and was chemisorbed to a standard microscope coverslip with (3-mercaptopropyl)trimethoxysilane. The gold surface was further modified with 1-hexanethiol to optimize hydrophobicity of the surface to allow for redox measurements to be made in nanoscopic volumes. Time traces of the open-circuit potential (OCP) were used to construct Nernst plots to evaluate the applicability of the droplet-based potentiometric redox measurement system. Two poised one-electron transfer systems (potassium ferricyanide/ferrocyanide and ferrous/ferric ammonium sulfate) yielded Nernstian slopes of -58.5 and -60.3 mV, respectively, with regression coefficients greater than 0.99. The y-intercepts of the two agreed well to the formal potential of the two standard oxidation-reduction potential (ORP) calibrants, ZoBell's and Light's solution. The benzoquinone and hydroquinone redox couple was examined as a representative two-electron redox system; a Nernst slope of -30.8 mV was obtained. Additionally, two unpoised systems (potassium ferricyanide and ascorbic acid) were studied to evaluate the system under conditions where only one form of the redox couple is present in appreciable concentrations. Again, slopes near the Nernstian values of -59 and -29 mV, respectively, were obtained. All experiments were carried out using solution volumes between 280 and 1400 pL with injection volumes between 8 and 100 pL. The miniscule volumes allowed for extremely rapid mixing (<305 ms) as well. The small volumes and rapid mixing along with the high accuracy and sensitivity of these measurements lend support to the use of this approach in applications where time is a factor and only small volumes are available for testing.

A highly addressable static droplet array enabling digital control of a single droplet at pico-volume resolution.

Droplet-based microfluidics enabling exquisite liquid-handling has been developed for diagnosis, drug discovery and quantitative biology. Compartmentalization of samples into a large number of tiny droplets is a great approach to perform multiplex assays and to improve reliability and accuracy using a limited volume of samples. Despite significant advances in microfluidic technology, individual droplet handling in pico-volume resolution is still a challenge in obtaining more efficient and varying multiplex assays. We present a highly addressable static droplet array (SDA) enabling individual digital manipulation of a single droplet using a microvalve system. In a conventional single-layer microvalve system, the number of microvalves required is dictated by the number of operation objects; thus, individual trap-and-release on a large-scale 2D array format is highly challenging. By integrating double-layer microvalves, we achieve a "balloon" valve that preserves the pressure-on state under released pressure; this valve can allow the selective releasing and trapping of 7200 multiplexed pico-droplets using only 1 μL of sample without volume loss. This selectivity and addressability completely arranged only single-cell encapsulated droplets from a mixture of droplet compositions via repetitive selective trapping and releasing. Thus, it will be useful for efficient handling of miniscule volumes of rare or clinical samples in multiplex or combinatory assays, and the selective collection of samples.

Tainted earth: smelters, public health, and the environment

Tainted earth: smelters, public health, and the environment

Forest biomass extraction for livestock feed and associated carbon analysis in lower Himalayas, India

Accounting the changes in the net carbon (C) sink-source balance is an important component for greenhouse gas emissions (GHG) inventories. However, carbon emission due to the vegetation biomass extraction for household purposes is generally not accounted in forest carbon budget analysis due to miniscule volume and non-availability of data. However, if vegetation remains in the forests, then vegetation biomass decomposes after natural death and decay and fixes some carbon to soil and releases some directly to the atmosphere. The study attempts to quantify the carbon removal against the biomass extraction for livestock feed by collecting primary data on feed from 316 randomly selected households engaged in livestock rearing in the lower Himalayas, Uttarakhand, India and carbon flow components due to livestock production. The analysis results that average daily forest fodder consumption was 13 kg per Adult Cattle Unit (ACU) and total of 20.31 Million tonnes (Mt) consumption of forest biomass by total livestock of Uttarakhand. This results into absolute annual carbon removal of 3.25 Mt from Uttarakhand forests against the livestock fodder. However, overall carbon flow including the enteric fermentation and manure management system of livestock estimated as per IPCC guidelines, results into emissions of 9.42 Mt CO2 eq. Therefore, biomass extraction for household purposes should be accounted in regional carbon flow analysis and properly addressed in the GHG inventories of the forests and livestock sector. Suitable measures should be taken for emissions reduction generated due to forest based livestock production.

Evaluating Spermatogenesis Using Semen: The Biology of Emission Tells Why Reporting Total Sperm per Sample Is Important, and Why Reporting Only Number of Sperm per Milliliter Is Irrational

Evaluating Spermatogenesis Using Semen: The Biology of Emission Tells Why Reporting Total Sperm per Sample Is Important, and Why Reporting Only Number of Sperm per Milliliter Is Irrational