This letter describes two methods for improving the transmission-conversion efficiency in microwave power transmission (MPT). On one hand, according to the obtained formula, the transmission-conversion efficiency can be improved by optimizing the amplitude distribution and phase distribution on the aperture of the transmitting antenna. On the other hand, when the distribution of the aperture is fixed and the equal amplitude with in-phase distribution is taken as an example, the transmission-conversion efficiency can also be improved by adopting nonuniform rectenna array. The transmission-conversion efficiency formula is rederived for this case since the size of partial units increases. Lastly, an MPT system is established, and the corresponding transmission-conversion efficiencies are calculated. Compared with the initial case where the transmitting antenna has an equal amplitude with in-phase aperture distribution and the receiving aperture is composed of a uniform rectenna array, the obtained transmission-conversion efficiencies of optimizing aperture distribution and nonuniform rectenna array increased by 25% and 24.9%, respectively. However, if the transmitting antenna is far from the rectenna array, the transmission-conversion efficiencies in these three cases tend to be the same.