microM Min Research Articles

Reverse reaction of smooth muscle myosin light chain kinase. Formation of ATP from phosphorylated light chain plus ADP.

Incubation of smooth muscle phosphorylated heavy meromyosin in the presence of myosin light chain kinase, calmodulin, ADP, and Ca2+ results in a decrease of the protein-bound phosphate. The dephosphorylation is not due to phosphatase activity and is dependent on the presence of ADP and the active ternary myosin light chain kinase complex. Using 32P-labeled phosphorylated 20,000-dalton light chains as the phosphate donor, the formation of ATP from ADP can be demonstrated. This reaction requires the presence of Ca2+, calmodulin, and myosin light chain kinase. These results indicate that myosin light chain kinase can catalyze a reverse reaction and form ATP from ADP and phosphorylated substrate. The rate of the reverse reaction, kcat/KLC approximately 0.21 min-1 microM-1, is considerably slower than the forward reaction under similar conditions and is therefore detectable only at relatively high concentrations of myosin light chain kinase. For the reverse reaction, KmADP is approximately 30 microM and ATP is a competitive inhibitor, KIATP approximately 88 microM. For the forward reaction, measured with both isolated light chains and intact myosin, KmATP is approximately 100 microM and ADP is a competitive inhibitor, KiADP approximately 140 microM (myosin) and 120 microM (light chains). Thus, the affinity of ATP for the forward and reverse reactions is similar, but the affinity of ADP is higher for the reverse reaction. From the light chain dependence of the two reactions, the following was calculated: forward, Km = 5 microM, kcat = 1720 min-1, and reverse, Km = 130 microM, kcat = 27 min-1. In contrast to the data obtained with isolated light chains, it is suggested that, with intact myosin as substrate, the Km term is primarily responsible for determining the rate of the reverse reaction. With light chains phosphorylated at serine 19 and threonine 18, it was shown that both sites act as a phosphate donor, although the reverse reaction for threonine 18 is slower than that for serine 19.

TiN x coatings prepared by d.c. reactive magnetron sputtering

In this paper we describe an investigation of the correlation between the microstructure, morphology and microhardness of non-stoichiometric TiN x films prepared by reactive d.c. magnetron sputtering in a narrow interval of partial pressure p N 2 of nitrogen. It was found that TiN x films sputtered at p N 2 < p N 2 crit have a quasi-amorphous microstructure and are extremely hard. The results of a detailed experimental study of the films' microstructure, morphology, microhardness and deposition rate are given. It is shown that reactive d.c. magnetron sputtering makes possible the production of TiN x films with the high deposition rate of 0.5microm min −1.

Identification, phosphorylation, and dephosphorylation of a second site for myosin light chain kinase on the 20,000-dalton light chain of smooth muscle myosin.

At relatively high concentrations of myosin light chain kinase, a second site on the 20,000-dalton light chain of smooth muscle myosin is phosphorylated (Ikebe, M., and Hartshorne, D. J. (1985) J. Biol. Chem. 260, 10027-10031). In this communication the site is identified and kinetics associated with its phosphorylation and dephosphorylation are described. The doubly phosphorylated 20,000-dalton light chain from turkey gizzard myosin was hydrolyzed with alpha-chymotrypsin and the phosphorylated peptide was isolated by reverse phase chromatography. Following amino acid analyses and partial sequence determinations the second site of phosphorylation is shown to be threonine 18. This site is distinct from the threonine residue phosphorylated by protein kinase C. The time courses of phosphorylation of serine 19 and threonine 18 in isolated light chains follow a single exponential indicating a random process, although the phosphorylation rates differ considerably. The values of kcat/Km for serine 19 and threonine 18 for isolated light chains are 550 and 0.2 min-1 microM-1, respectively. With intact myosin, phosphorylation of serine 19 is biphasic; kcat/Km values are 22.5 and 7.5 min-1 microM-1 for the fast and slow phases, respectively. In contrast, phosphorylation of threonine 18 in intact myosin is a random, but markedly slower process, kcat/Km = 0.44 min-1 microM-1. Dephosphorylation of doubly phosphorylated myosin (approximately 4 mol of phosphate/mol of myosin) and isolated light chains (approximately 2 mol of phosphate/mol of light chain) follows a random process and dephosphorylation of the serine 19 and threonine 18 sites occurs at similar rates.

Displacement of DL-[3H]-2-amino-4-phosphonobutanoic acid ( [3H]APB) binding with methyl-substituted APB analogues and glutamate agonists.

The binding of the excitatory amino acid antagonist DL-2-amino-4-phosphonobutanoic acid (DL-APB) to rat brain synaptic plasma membranes was characterized. As determined by Scatchard analysis, the binding was saturable and homogeneous with a Kd = 6.0 microM and Bmax = 380 pmol/mg of protein. The binding was dependent on the presence of Ca2+ and Cl- ions and was diminished upon freezing. The association rate constant was 6.8 X 10(-3) microM-1 min-1, and the dissociation rate constant was 2.0 X 10(-2) min-1. The L isomers of APB, glutamate, and aspartate were more potent as displacers of APB binding than the D isomers. Previously determined inhibition data obtained for APB-sensitive inputs to hippocampal granule cells are compared to the present displacement data in an attempt to identify this binding protein as the recognition site of the receptor mediating the APB-induced inhibition of synaptic transmission. With the exception of kynurenic acid, all compounds examined in both systems were more potent as displacers of APB binding than as inhibitors of synaptic transmission. This difference in potency was most pronounced for agonists at dentate granule cells. L-Glutamate, D-glutamate, and L-glutamate tetrazole were between 140- and 7500-fold more potent as displacers of DL-APB binding than as inhibitors of synaptic transmission. D-2-Amino-5-phosphonopentanoic acid and alpha-methyl-APB were between 10- and 20-fold more potent as displacers of binding.(ABSTRACT TRUNCATED AT 250 WORDS)

In situ observations on amorphous versus crystalline growth of silicon by chemical vapour deposition

Polycrystalline and amorphous silicon films were grown in an r.f.-heated reactor at atmospheric pressure. The growth rate was varied between 3 × 10 −3 and 2 microm min −1 at temperatures between 560 and 860 °C. As a result of in situ observations by means of simultaneous time-resolved optical reflectivity and emissivity measurements, not only could the growth rate and surface temperature be determined but also new information could be obtained about the nature of the growing film and its surface condition. After growth X-ray diffraction and microscopy were applied to complete the analysis. It was found that, dependent on the growth rate, above about 700 °C crystalline growth is prominent resulting in a rough surface and cone-shaped grains with a preferred 〈110〉 orientation, whereas below 620 °C the resulting layer is amorphous with a smooth surface. The intermediate temperature region is interesting as the initial growth is amorphous, while during growth crystallization occurs. At the lower and the higher temperature sides of this region different nucleation mechanisms are operative resulting in different textures. Conditions are specified under which a surface quality and grain size are obtained best suited for use in integrated circuit technology.

Chemical vapour deposition of titanium oxides in the composition range TiO 1.60–TiO 1.75

Ti 3O 5 and Ti 4O 7 were grown by chemical vapour deposition in a hot-wall reactor at 1015 °C and a total pressure of 50 Torr. The reaction gas mixture contained TiCl 4, CO 2 and H 2. For growth of single-phase coatings the vapour composition has to be controlled accurately. Ti 3O 5 was grown at near-equilibrium conditions, while Ti 4O 7 could only be grown under conditions far from equilibrium. The coatings grew at a rate of about 0.3 microm min −1 and consisted of well-shaped columnar crystals.

A functionally active heavy chain derived from human high molecular weight urokinase.

Human high molecular weight urokinase, a plasminogen activator, when minimally reduced with 0.01 M 2-mercaptoethanol for 10 h at pH 8.0 and 25 degrees C and then carboxymethylated with sodium iodoacetate, gave two chains, a functionally active heavy chain with about 80% of the original activity and a light chain. These two chains were found to be linked by a single interchain disulfide bond. The functionally active heavy chain can be isolated by an affinity chromatography method with [N alpha-(epsilon-aminocaproyl)-DL-homoarginine hexylester]-Sepharose. The light chain, which has no enzyme activity, is not adsorbed to the affinity matrix, whereas the active heavy chain was adsorbed and subsequently eluted. The active heavy chain was further purified by gel filtration on Sephadex G-100. This preparation was found to be homogeneous by both analytical and sodium dodecyl sulfate-polyacrylamide disc gel electrophoresis. The molecular weight of the active heavy chain was determined to be 33,000 by Sephadex G-100 gel filtration and 31,000 by sodium dodecyl sulfate-polyacrylamide disc gel electrophoresis. Its specific activity, with L-pyroglutamyl-glycyl-L-arginine-p-nitroanilide, was determined to be 208,000 IU/mg of protein. Approximately 87% active sites were found by p-nitrophenyl-p'-guanidino-benzoate titration with a molar activity of 7.41 X 10(9) IU/mmol of active site. The active heavy chain when compared to low molecular weight urokinase has a similar molecular weight, specific activity, and amino acid composition. The NH2-terminal residue found in the active heavy chain was lysine which was the same as that found in low molecular weight urokinase, whereas the NH2-terminal residues found in high molecular weight urokinase were serine and lysine. Serine is the NH2-terminal residue of the light chain of high molecular weight urokinase. The steady state kinetic parameters of activation of human Glu-plasminogen by the active heavy chain were also similar to low molecular weight urokinase, as were the amidase parameters of these enzymes. The Michaelis constants of activation (Kplg) were 2.11 and 2.21 microM, respectively; the catalytic rate constants of activation (kplg) were 51.7 and 44.1 min-1, respectively, with second order rate constants, kplg/Kplg of 24.5 and 20.2 microM-1 min-1, respectively.