This research aims to identify a high-quality, efficient, and low-cost micro-hole drilling process through glass plates that employs an electroplated diamond tool with different drill bits. Three different drill bits were tested to determine how varying the chip discharge volume influences chip discharge performance, which is an important factor that affects the effectiveness of the drilling process. The chip discharge performance of each electroplated diamond tool was experimentally investigated by observing the drilling quality and the number of the drilled holes. From the experimental results, it was found that the drilled chips could not discharge smoothly when the drill bit possesses a small chip discharge volume, leading to the drill bit breaking, which thus limits the number of drilled holes. Furthermore, the changes in thrust force and the crack size were high, and there were also cracks on the drilled glass plate. However, drilling with a drill bit that possesses a larger chip discharge volume resulted in excellent chip discharge performance and increased the number of drilled holes. This type of drill bit is effective in drilling holes through glass plates, with minimum hole defects and no issues associated with chips clogging the hole during drilling.
Read full abstract